PDA

View Full Version : blower switch plate ??



jmvotto
05-22-2010, 02:00 PM
My blower switch plate face popped off. Any ideas how to get it back on? It does not look broken, but when i push hard it does not snap on, i am afraid to push really hard and break the panel.

any suggestions?

cab13367
05-22-2010, 04:05 PM
My blower switch plate face popped off. Any ideas how to get it back on? It does not look broken, but when i push hard it does not snap on, i am afraid to push really hard and break the panel.

any suggestions?

Joe,

I recently changed a ballast switch faceplate to a heater faceplate and I don't remember anything special about installing the new switch. I think there are two tabs, one on each side of the switch that just snapped in. Maybe u don't have the tabs lined up right??

Al

jmvotto
05-23-2010, 07:42 AM
Al, not the whole switch just the cover on the switch....

cab13367
05-23-2010, 10:43 AM
Al, not the whole switch just the cover on the switch....

Yes, cover, facepate, same difference :) I changed only the cover as well. Did u get it back on?

jmvotto
05-23-2010, 11:38 PM
Not yet, it wont snap back into place looks like a little piece is missing for the snap on, i could probaly use a little silicone or gorilla glue on the center stud to adhere it.