PDA

View Full Version : Help troubleshooting ballast system



jamie_abb
07-12-2010, 10:36 AM
Tried to fill the bags on the weekend and had a few problems

1. the live-well pump wouldn't run - tried it hooked up to one of the solenoid plugs and bam it works - I could find fuses for the solenoids and drain pumps but not for the main pump - is it a line fuse? any help?

2. Thought I was filling only the left bag - nope - both bags and 1500 lbs later - what position should the solenoid switches be in for the dash toggles switches to control?

Thanks,
J

jamie_abb
07-13-2010, 10:40 AM
Does anyone know if there is a line fuse, fuse or other for the ballast pump?

moombadaze
07-13-2010, 12:05 PM
On mine the fuse for the fill pump was up on a seperate fuse block just for the balast system under the dash.

jamie_abb
07-20-2010, 05:36 PM
I have the fuse block located - three fuses for the solenoids and three for the drain pumps - where be the fuse for the fill pump which should turn on when any of the fill switches are hit?????

jester
07-27-2010, 05:07 PM
I think if you look up from under the dash you should see three relays. There is an inline fuse connected to the system. You might have to track back the wires from the switches.

jamie_abb
08-09-2010, 12:56 PM
Ballast system now working - I think the relay was loose

Anyone know what the specs are to replace one sprinkler valve?

kaneboats
08-10-2010, 12:53 PM
I replaced one sprinkler valve with an Irritrol 700 series that I use on the surf bag (750). It cut the fill time for that bag close to in half. The other two bags are just 400's so I didn't bother changing them out. I run dual Rule pumps.

jamie_abb
08-11-2010, 10:29 AM
Do you have a picture of the dual rule pumps installed?

kaneboats
08-11-2010, 11:21 AM
Sure do. But, Newty's pic (2nd one) is better. Here you go: