PDA

View Full Version : pulling the floor in OBV07



jmvotto
08-18-2010, 10:30 AM
Has anyone one pulled the floor in an 06 to 08 OBV or a pre-06 lsv. Is it a one man job? or will i need two people to help get the floor out. It may be awkward but i think i should be able to get it. Ballast project her i come....:rolleyes:

mcdye
08-18-2010, 01:33 PM
i recall some threads conerning replacment of the steering cable and it was 2 man job to lift it out.

2007 Outback V
08-18-2010, 10:39 PM
Why do you need to pull the floor? It is not that hard to do, but it would be nice to have an extra hand to lift it out.

jmvotto
08-18-2010, 10:52 PM
GI to GIII upgrade, the oem wiring harness is not long enough to go around the side walls

NCSUmoomba
08-19-2010, 09:14 AM
Is that even possible? In my boat, the floor is bonded to the hull and is not removeable. The only parts I can remove are the parts screwed down.

cab13367
08-19-2010, 11:05 AM
GI to GIII upgrade, the oem wiring harness is not long enough to go around the side walls

Joe,

On my boat, there are two panels and it's easily a one person job. Not sure about yours though.

Al

Sharpie647
08-19-2010, 11:31 AM
I pulled my floor in my 02 lsv. Took two of us. maybe this thread would help

http://moomba.com/msgboard/showthread.php?t=3946&highlight=cable

VA LSV
08-19-2010, 12:14 PM
There are screws in the edge of the floor in addition to the chrome ones you see in the carpet. I didn't know about them when I upgraded from GI to GIII so I ran the OEM wiring harness around the drivers side.

moombadaze
08-19-2010, 07:54 PM
pulled the floor in my 03 lsv myself. not that hard at all. Just those screws hidden under the rear seats were a pain