PDA

View Full Version : Snap Cover



squeeg333
07-19-2011, 02:45 PM
So, this is probably a dumb question, but I'll ask it anyway...

A few of the snaps on the bow setion of my snap cover have always been very loose. And what I mean by that is the cover un-snaps very easily. All of the rest of the snaps hold really well, but there are two or three that don't hold too well.

I don't really want to replace the snap portion that is threaded into the boat, but do you guys think this is probably the best option?? Or is there another way to 'tighten' snaps??

mnpracing
07-19-2011, 03:07 PM
I had a snap cover on my '06 OBV and routinely had to replace snaps (the ones on the canvas, not the boat). I would try that as I found that usually fixed the issue. Once in a while I had to snug up the screw holding the snap down to the fiberglass, but it was rare. I just bought a snap kit at Fleet Farm for about 5 bucks for 100 snaps.