View Full Version : Winterizing - Water in Hull?
10-10-2011, 10:28 AM
I following the winterization procedure yesterday. But when I took out the center ballast sac I notice a lot of water still in the hull. I pulled up on a little hill to let it drain out the rear drain plug, and even re-connected the battery for the bilge to work (which it did). But I still had some water in the hull. Here in Michigan that water will freeze for sure. It seems as though I could never get all of that water out...so what do I do about it?
For how I poured some pink intifreeze into the water to mix with it and hopefully keep from freezing.
Any other suggestions?
10-10-2011, 10:32 AM
Do you mean just water sitting in the bottom of the ski locker/engine compartment? I just use some towels and/or a shop vac depending on how much is in there. That will get almost all of it, then just leave it open a bit to fully dry out.
However, I've seen a thread or two where people were describing water under the floor. If that's what you mean then I'm not sure.
10-10-2011, 10:34 AM
Both, in the ski locker and under the floor.
10-14-2011, 10:02 AM
Anybody...? I can't believe I'm the only one with this? Any help would be greatly appreciated. (It's getting colder by the day here in Michigan and I would like to resolve, if I need to, before the first big freeze.)
10-14-2011, 10:05 AM
There is/was an extensive thread on getting rid of the water under the floor. In brief, folks were cutting a hole in the center ski locker floor and the foam underneath so that they could use a shop vac to extract the water. Most installed some sort of acess cover over the hole. If I have a minute, I'll search for the thread.
Good luck & stay warm!
10-14-2011, 10:08 AM
Here is the thread I was thinking of. Hope this helps.
10-14-2011, 10:23 AM
You should be able to get all the water out of the ski locker/blige area with a shopvac, then put a fan on it for a day or two to totally dry it out.
10-14-2011, 11:34 AM
Thank you both! This is what I'm looking for.
Powered by vBulletin® Version 4.2.0 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.