PDA

View Full Version : Oil filter



tnbrooks01
08-30-2012, 12:38 AM
Anyone else have issues with the oil filter being extremely difficult to take off? It seems that no matter how I try to put it on just snug enough to prevent leaking it is still very tight when time to change oil. Tonight it turned a 10-15 minute job into a 3hr/ 5 beer job. I ended up sticking a screwdriver through the side of the filter and using it as a lever to finally get the filter broke loose.

wolfeman131
08-30-2012, 12:43 AM
I had a major issue getting it off the OBV first time I changed it out myself. I try and make sure I now put a good coat of fresh oil on the ring and the underside of the mount.

beat taco
08-30-2012, 01:13 AM
No leverage issues here. 15948

ga-lsv05
08-30-2012, 03:45 AM
Oil filter socket or band wrench will address your issue

2005 mobius lsv 2900lbs ballast

tnbrooks01
08-30-2012, 09:03 AM
Oil filter socket or band wrench will address your issue

2005 mobius lsv 2900lbs ballast


I always coat the gasket with fresh oil.
Broke 2 strap wrenches last night. Gonna try the filter socket next time.

04OUTBACK
08-30-2012, 09:26 AM
Plus side is you did get 5 beers out of the job :-) :o

Been a few issues around here.. some worse than others..
I never had any real issues on my outback or LSV. just now due my next oil change on my supra, if i get to go use it anytime...

z28ke
08-31-2012, 06:56 PM
I use filter pliers which usually crush the filter trying to remove it but it comes off. One thing I always do is loosen the bolts that hold the filter receiver(don't know the actual name, maybe remote filter mount) to the bracket. It's such a tight fit the bracket will scrape the filter.

kaneboats
09-01-2012, 12:55 AM
A long time ago I started just putting it hand tight with no wrench. I've never had a leak and still usually have to use a wrench to get it off (leave the Mom joke out of this one). I think the rubber on the seal hardens up from the heat and makes it harder to get off (see previous parenthetical comment).

lewisb13
09-01-2012, 12:58 AM
This next boat I'm going to the k&n because they have a 15mm nut welded on the bottom

jdntexas
09-01-2012, 07:28 PM
I use K&N filters on my boat and a Ford truck. They ain't cheap but they're well built and can save you some beer money when it comes time to change! Being able to use a socket wrench in a tight spot makes me willing to spend a little more just for the convenience.

http://www.knfilters.com/marine/maroilfilter.htm

wolfeman131
09-01-2012, 10:23 PM
Jerry,

When did you put that signature in? I love it! Keep reading and asking questions and the guys on here will help you get what you want/need.

jdntexas
09-01-2012, 11:20 PM
Hey Drew. Yeah, I'm exploring the Moomba site and wanting to pick up what I can on these boats. I'm not sure when I'll be able to make the transition but time is on my side. If and when it happens, I want to make the best decision on that next boat. This is a good board and I can gain a lot of insight here on how Moomba's work! Look forward to getting to know ya'll.

wolfeman131
09-01-2012, 11:44 PM
Look forward to getting to know ya'll.

Do so at your own risk!