View Full Version : 2001 Moomba Kamberra Kill Switch
05-11-2007, 10:29 PM
Hello all, I am a new owner of a 2001 Moomba Kamberra with a Chevy 350 engine. I noticed the boat did not have the optional kill switch and was wondering if I could install myself and if so where I might find some instruction or if I should just let a pro do it? Any help is appreciated.
05-12-2007, 04:39 AM
Piece o cake.
Get you a kill switch like those that are the kind you want. West Marine or Boater's World (maybe Wally World, but I doubt it).
Find the 'run' wire on the ignition switch. You can do this by using a volt meter if you haven't got a wiring diagram. Mount the kill switch, sever the run wire, attach the ends to the switch. It doesn't matter which side, because all the switch does is complete the circuit.
You can test it by turning the ignition switch to the 'run' position and checking for voltage across the kill switch. Popping the lanyard off should cut the voltage.
Hope this helps
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.