View Full Version : Wakeplate Position Indicator Gauge
07-12-2008, 06:17 AM
My wakeplate works fine but the position indicator gauge is stuck. I suspect there is a problem with the sensor on the cylinder.
Anyone have anidea where the sensor is or what else could be wrong?
Thanks in advance!
07-12-2008, 09:57 AM
I had the same problem. I took it to my dealer and they found that it was just a loose wire on the back of the gauge.
07-12-2008, 12:56 PM
Thanks for the heads up. I'll check it out tomorrow morning when we get to the lake.
07-15-2008, 10:54 PM
You nailed it. I cut and re-crimped the 3 wires going into the gauge and wallah, it works again!
Thanks for the direction, I owe you one!
07-17-2008, 01:53 AM
OUTSTANDING!!! I'm glad I was able to contribute to this great board.
Powered by vBulletin® Version 4.2.0 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.