View Full Version : Quick Winterization drain plug valves
12-17-2008, 02:14 PM
I remember a post on these.............but i cant find it. Any thoughts?
12-17-2008, 03:50 PM
Check those out I like the first one.
I ended up just going to the hardware store and I found the same size brass screws that were in my engine blocks except they were in a thumb screw version
No tools required but I use a pair of channel locks to do one last half twist after I tighten with my fingers to make sure they are in there good and snug to prevent leakage.
If I lived where you lived I would at least do what I did or do the easy drain valves that are listed on the first link.
The exhaust headers have a connecting hose to drain those as well.
We kept a single small wrench for removing the drain plugs every trip during the winter, one plug located on the bottom side of each 4 block.
This is from an easy to access 2007 Moomba Outback DD.
01-04-2009, 03:48 AM
I use brass drain plugs that aren't expensive, easy to drain and won't break or loosen up.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.