PDA

View Full Version : swim platform covering?



moombadaze
02-02-2009, 11:18 AM
I would like to get some of the material that is used on the swim platform to put on the gunwales for where my tower arms fold down and to put across the stern for some protection from boards marking it up.

thanks

moombadaze
02-02-2009, 04:20 PM
Ed, ill keep that in mind but if you want to pitch it thats cool. I was looking fot the exact matching. Any ideas were to get it?

Sled491
02-02-2009, 09:19 PM
Well Daze here's just a thought. Why not competely custom and order yourself a new Seadek platform cover and get them to make you up some tric gunwale protectors to match?

kaneboats
02-02-2009, 09:53 PM
Can't remember what color you need?

moombadaze
02-03-2009, 07:17 AM
Well Daze here's just a thought. Why not competely custom and order yourself a new Seadek platform cover and get them to make you up some tric gunwale protectors to match?

I've been thinking about doing that.

Sled491
02-03-2009, 08:58 AM
Daze, I'll tell you I find his stuff fairly reasonable in price, especially considering the quality and the tricked out look.

moombadaze
02-03-2009, 10:02 AM
Speaking of the Tampa Jam-i stopped in and talked with the dealer last week and he said he would like to do another one this summer if he can. I will post more info later.

yearround
02-03-2009, 10:33 AM
daze,
i think we have the same color as you. we used blue/white gator grip for the swim deck and gunwale step. my custom amateur cutting is not a good as seadec, but it works. i don't fall as often stepping up for a board. i don't have a pic specific of the gunwale, but this is close. i will try and get out to get a shot.

flaswaliba
02-03-2009, 11:07 AM
yearround,

did you remove the old "non-skid" and replace it with the gator grip, or did you just apply the gator grip over the old material from the Moomba?

Thanks,

The Flas

yearround
02-03-2009, 04:37 PM
pulled the old black stuff off. used lots of different things to get the adhesive off, some else had said to use carb leaner, i didn't have that to try. used goof off, adhesive remover, etc.

kaneboats
02-03-2009, 04:47 PM
Speaking of the Tampa Jam-i stopped in and talked with the dealer last week and he said he would like to do another one this summer if he can. I will post more info later.

I'm there!

Sled491
02-03-2009, 05:32 PM
I found pulling it off in pcs and cutting the chunks off seemed to help the peeling off process. But again it was like 40 degrees when I did mine outside