View Full Version : drilling through carpet for ballast hose
02-16-2009, 12:23 PM
I was going to add some custom fat sacs underneath my seats and wanted to drill (hole saw) a hole underneath the seat supports that sit perpindicular to the bow/stern line of the boat. It would be about a 1" hole that would allow a hose to pass through and connect one bag (the rear) to another so that they could both fill/empty off of the stock gravity ballast plumbing.
I was wondering if anyone has drilled through the carpet and how it reacts? (frays, unravels, or is fine?) I see the new 09's come with a hole precut and carpeted over already.
Any info appreciated.
02-16-2009, 07:32 PM
John- sorry i just saw that all the photos in the other thread are gone but this is what i did.
dremil to cut with
cooler begining to comeout
rear gravity 3 bag under the seats- i plummed it in
rear surf bag and under seat bag filled iwth air for the photo
02-16-2009, 07:34 PM
this is what it looks like all filled up
also put a 400lb bag on the seat
hope this helps with your mod
02-17-2009, 02:12 PM
I really can't wait to see this surf wake.
02-17-2009, 02:46 PM
Still working on it, think i need more weight up front. Looked like the swim platform was still draggin in the water. Other issue i had was the lake level--its low
02-17-2009, 02:55 PM
yep more up front-i would just take the sac i have on the seat and try it up front--still experamenting
02-17-2009, 02:57 PM
You have 25 days to get it dialed in. I haven't even changed my oil yet, much less done anything about wake. I don't know if I'll even have one by 3/14. I did start cleaning yesterday and finished the sub and amp install though.
02-17-2009, 03:06 PM
25 days i wish--more like 4 days off. i need to get amp and tower speaker wires tidy'd up.
02-17-2009, 10:35 PM
Going back to you drilling through carpet. I've never made a hole that large through carpet but have done something similar on a much smaller size and asuming the carpet is mostly nylon you could try using a hole saw bit and heat the end and sear/melt the carpet ,like a doughnut hole then the carpet will not run when you very carefully drill through the carpet to make a nice clean hole.Just a thought.I've done something like this fastening a closet track over carpet and heat nails/screws so they don't snag and cause runs.Depends on the carpet by nylon melts quite easily. Very similar to heating the ends of a rope and twisting carefully in your fingers.
02-17-2009, 11:40 PM
I would start the hole saw until it touches the carpet then score the carpet around the saw with a knife then continue drilling carefully. I've done that with no probs.
02-18-2009, 11:46 AM
Agree- put a new blade in your utility knife and get a good cut.
02-18-2009, 12:02 PM
Thanks for the info guys
Powered by vBulletin® Version 4.2.0 Copyright © 2015 vBulletin Solutions, Inc. All rights reserved.