View Full Version : V-drive water cooling area - sticks
11-30-2009, 11:42 PM
As you might know i have had an issue getting out the square bolts so i decided to pull the top plate. EASY. 6 bolts that a 1/2 socket fits and pulls off easy. Everyone might want to pull this off at least every other year since how it is setup it will collect junk you have sucked up. I found a few sticks in this area that could have started a bigger build up. I have attached a pic so everyone can see what it looks inside this area. Sorry for the bad pic it was taken from my cell phone. Also even with pulling both drain bolts a little water still sits in this area.
12-01-2009, 07:20 AM
I also had trouble getting the steel square drain plugs out. They were also extremely rusted. Chased the threads with a 1/4" pipe tap and installed brass hex head plugs so I can use a 9/16 socket.
Pulled my top cover last year and found some little sticks. No way to reuse the original gasket so made one out of RTV. Also replaced the bolts with anodized and anti-sieze since the originals were very rusted.
12-01-2009, 02:10 PM
do you two guys have a water strainer?
12-01-2009, 05:08 PM
No strainer. Thinking of putting one in.
12-01-2009, 09:21 PM
it is cheap insurance. if have not you should probably check further up stream at the strainer in tranny fluid cooler.
12-14-2009, 10:59 PM
I put "never sieze" on everything. No problems since.
Powered by vBulletin® Version 4.2.0 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.