Tab Content
  • jzelt's Avatar
    Yesterday, 10:40 AM
    jzelt replied to a thread Bilge Question in General Chat
    I have never done it, but I would be inclined to use some dish soap on the drive shaft to lubricate it so it slid easier thru the seal. (No delicate...
    23 replies | 616 view(s)
  • jzelt's Avatar
    07-07-2014, 11:27 AM
    Second Trayson's list. Small tool kit like his that fits in the cubby hole. Was my nicest tool set for a while... Plumber wrench with handle...
    16 replies | 337 view(s)
  • jzelt's Avatar
    07-07-2014, 11:17 AM
    ^^^Exactly. Fried with Straub beer or butter. Venison (Deer) is pretty dry, so we make dumplings with that ground up.
    4 replies | 126 view(s)
  • jzelt's Avatar
    07-07-2014, 11:16 AM
    jzelt replied to a thread Bilge Question in General Chat
    It would drip from the packing nut. If you have water to the bottom of that, then you aren't going to see it drip. (Try getting everyone to the bow...
    23 replies | 616 view(s)
  • jzelt's Avatar
    07-01-2014, 01:59 PM
    I agree, I tighten the nut with channel locks till it is pretty tight, back it off a ways, then hand tighten to where the cotter pin will go thru.
    14 replies | 383 view(s)
  • jzelt's Avatar
    06-30-2014, 12:40 PM
    I use mothers mag and aluminum polish. Put some on the tubing, then take a rag and wrap it around once and pull it back and forth like the "old" fire...
    2 replies | 107 view(s)
No More Results
About jzelt

Basic Information

About jzelt
Western PA


2004 Supra 22 SSV
325 Indmar Assault 320 HP
"One more hour"


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 09:58 AM
Join Date