NCSUmoomba
Senior Member
Find latest postsMini Statistics
- Join Date
- 10-09-2005
- Last Activity
- Yesterday 05:32 PM
- Avatar
More 2 Friends
Recent Visitors
This page has had 2,091 visits
- Tab Content
- NCSUmoomba's Activity
- About Me
- Friends
- Tab Content
-
Older Activity
-
Yesterday, 11:35 AMBerg, You have Perfect Pass, right? It has a water temperature reading. Well, the paddle wheel version does, I guess the Stargazer doesn't.10 replies | 90 view(s)
-
Yesterday, 11:17 AMBummer. But where did the idea that boats are supposed to be cheap come from!?!?3 replies | 76 view(s)
-
Yesterday, 11:15 AMI'll put my 2 cents in here. First, a dry bilge? What is that? If you have a dry bilge, you are playing hard enough! As for which shaft seal to...24 replies | 328 view(s)
-
Yesterday, 11:07 AMIf you want to run it in gear to check it out, spray it with water while it spins. And don't rev it up too high.10 replies | 835 view(s)
-
Yesterday, 10:55 AMWell, it looks like the like to the PDF is missing. Here is a link to a post on Planet Nautique with the text of the letter. ...28 replies | 408 view(s)
-
Yesterday, 10:54 AMHere is an old post where we talked about ethanol use. http://www.moomba.com/msgboard/showthread.php?14756-Great-ethanol-information28 replies | 408 view(s)
-
Yesterday, 10:43 AMAs Mike mentioned, if you every watch a tandem trailer while turning, one of the axles is basically dragged sideways. It is pretty weird to see, but...5 replies | 105 view(s)
-
Yesterday, 10:24 AMMaybe it is just good luck, but the fix I did is easier than all of that. My boat vapor locked a couple of times, very aggravating, and I do change...22 replies | 434 view(s)
-
05-06-2013, 06:20 PMI think mine came with lock washers? A nylock nut could probably work as well.13 replies | 267 view(s)
-
05-06-2013, 06:19 PMI think the auto parts stores sell a sheet of gasket material so that you can make your own.3 replies | 104 view(s)
-
05-06-2013, 06:15 PMWow, I didn't know that the torsion axles were an option. What are the pros and cons of both setups? With all the torsion axles failure that seem to...10 replies | 348 view(s)
-
04-25-2013, 10:23 PMWhat I do is to stuff a few in the bow area up between the inner and outer hull in my Outback. They are not "easily accessible" but they do get out...16 replies | 403 view(s)
-
04-23-2013, 09:49 PMWow, very thourough, and well done. Doesn't the seat sit more upright now though?7 replies | 220 view(s)
-
04-23-2013, 09:42 PMI'm with blackout, I use the Penzoil Marine 15W40 just like the manual says. I have to get it at the local Mastercraft dealer. I use the Penzoil PZ3...29 replies | 808 view(s)
-
04-23-2013, 09:39 PMThe entire workshop is twice the size of my house, but half of it is a rec room with a kitchen, bathroom, pool table, etc. The door is only a 9x8, so...13 replies | 496 view(s)
-
04-23-2013, 09:32 PMI'm sure some place like West Marine would have some as well, maybe not the exact one.6 replies | 116 view(s)
About NCSUmoomba
Basic Information
- Date of Birth
- July 22, 1977 (35)
About NCSUmoomba
- Location:
- Durham, NC
Signature
Brian Roberts
2001 Outback DD
2001 Outback DD
Statistics
Total Posts
- Total Posts
- 553
- Posts Per Day
- 0.20
General Information
- Last Activity
- Yesterday 05:32 PM
- Join Date
- 10-09-2005
- Referrals
- 0