- Tab Content
- blackout_58's Activity
- Visitor Messages
- About Me
- Friends
- Tab Content
-
Older Activity
-
06-16-2013, 09:01 PMThat sounds much better. If they replaced it on summerization then they would have verified correct operation and all should be good. Will be...18 replies | 260 view(s) -
06-16-2013, 08:07 PMThis is so wrong, why would you ever load a new impeller over the winter.......put it in for summerization.....sorry, I just can't help myself when...18 replies | 260 view(s) -
06-16-2013, 12:38 PMIf the tstat is stuck closed then all the water will pass thru the tstat housing to the exhaust. If your exhaust cooling hoses are melted ,I would...18 replies | 260 view(s) -
06-15-2013, 12:53 PMUpdate on progress. Had a little design delay since last pics. All good now I suspect this week will go faster now that the bracing is...20 replies | 586 view(s) -
06-12-2013, 11:42 PMyou can get the seals from OJ props or skidim. you have to determine if its the housing or the seal leaking. the cooling water line should be from...6 replies | 128 view(s) -
06-10-2013, 05:27 PMIf its a hot day could be the case. the heat in the engine compartment gets so hot that the fuel in the pump turns to vapour and an increased...6 replies | 94 view(s) -
06-09-2013, 05:17 PMIts the trailers fault ......you can tow your boat-less trailer with straps but should not drive your trailer-less tow boat with straps13 replies | 370 view(s) -
06-09-2013, 05:09 PMYou most likely have a regular shaft seal, unless it was upgraded after purchase, which can be tightened to reduce the leaking. It shouldn't vary...6 replies | 128 view(s) -
06-07-2013, 09:53 PMThanks David Wolfe I want them for my EL Camino21 replies | 423 view(s) -
06-07-2013, 10:14 AMJoe not sure what the factory kicker amp is.. i think it is 250.4.. probably underpowered even for the kickers :-) Appreciate the response.....21 replies | 423 view(s) -
06-07-2013, 08:28 AMGood one Joe!9 replies | 258 view(s) -
06-07-2013, 08:21 AMIAN, love the sunset pic.. and the boat looks AWESOME! Congrats on Junior too!91 replies | 3952 view(s) -
06-07-2013, 08:17 AMcall Cecil at Elberts.com Great company.. great guy.. great service. WHen i needed a shaft and some parts, i called late on thurs aft, paid for...12 replies | 208 view(s) -
06-07-2013, 08:15 AMSo, I am very pleased with my stereo... (4 Exile SXT65s on Tower with Harpoon, Exile 12" sub with 1500.1) and have a ZLD to install. In boat i...21 replies | 423 view(s) -
06-05-2013, 08:48 AMGrady. Don't be playing loud music out there. Johnny Law Randy will pull you over!!! He harassed me last weekend at the boat ramp and I hadn't...13 replies | 355 view(s) -
06-04-2013, 10:51 PMDOCDRS replied to a thread dam wakeboarders with loud music and not obeying the rules. in General Chatglad I live in canada where no one owns the water15 replies | 576 view(s) -
06-02-2013, 09:05 PMyou can always heat the hose with a torch an then snug it to get a perfect seal.......but anything before the impellar should not leak as its under...6 replies | 160 view(s) -
06-02-2013, 08:38 PMthanks, i finished p all the soffit and fascia this weekend, probably wont do the trim for a bit , but shes all bug and weather tight. Now i can...7 replies | 286 view(s) -
05-30-2013, 07:47 PMDOCDRS replied to a thread Cleaning threads of block drain ports and transmissions drain plugs in General ChatThat way they can justify a paltry to exorbitant summarization charge.10 replies | 237 view(s) -
05-30-2013, 04:58 PMMemphis boat center is the only place in Memphis that I go to, and they have slim pickings when it comes to variety of boards. They do have some...12 replies | 216 view(s) -
05-30-2013, 04:44 PMIf its at the hull then you need to check you screws on the outside of the hull. you may be able to tighten them if they are loose or clean and...6 replies | 161 view(s) -
05-28-2013, 09:49 PMDidn't get much pics of the boat but got this one. Had a great 3 days out on lake. This was a joke from work Wife beater nice rack shirt :-)242 replies | 10095 view(s) -
05-28-2013, 09:38 PMMOOMBA forum member Grady is on the same lake. So we could host a few at a time for sure. He has LSV so we could have a good time out! Back of...20 replies | 586 view(s) -
05-28-2013, 09:27 PMI'd be in. Logo only if supra was an option ;-). Maybe include the supra Crew on that forum too.30 replies | 838 view(s) -
05-28-2013, 05:44 PMI can confirm everything that took place as 100% accurate with my first oil change also, except the injury......15 replies | 351 view(s) -
05-28-2013, 01:44 PMlewisb13, it'll have a hanging lift in it... cradle lift... The designer just showed a boat in it for looks. thats on a short canal to main lake...20 replies | 586 view(s) -
05-28-2013, 01:09 PMSounds great!20 replies | 586 view(s) -
05-28-2013, 11:53 AMafter a few delays.. and a few more.. here it goes! Drawings from Plan Stage One.. Concrete Seawall Stage 2: Pilings.20 replies | 586 view(s) -
05-23-2013, 06:11 PMwoooo hooo I see the vaseline no no is slowly spreading24 replies | 497 view(s) -
05-22-2013, 08:54 PMdid you stabilize the fuel last fall and is the throttle in the neutral position, if its in the flooded engine position this will stop fuel from...17 replies | 276 view(s)
1 Visitor Messages
About blackout_58
Basic Information
About blackout_58
- Location:
- Memphis, TN
- Occupation:
- Biomedical Engineer
Signature
2011 Supra 21V
Statistics
Total Posts
- Total Posts
- 14
- Posts Per Day
- 0.04
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 07-16-2012 11:27 AM
General Information
- Last Activity
- Yesterday 11:45 PM
- Join Date
- 05-29-2012
- Referrals
- 0
