- Tab Content
- jdntexas's Activity
- Visitor Messages
- About Me
- Friends
-
Older Activity
-
Today, 01:53 PMWell you see that is the very edge of what used to be a golf course (we just found out the golf course closed and sold out to a developer like a...81 replies | 1466 view(s) -
Today, 07:49 AMHow about gets some hdpe type plastic to build a frame for the area you want covered then install some plexi glass over the the frame. you can drill...12 replies | 123 view(s) -
Yesterday, 11:11 PMWell I have that large hump from the factory there and I have an IBS user the bow too but with the IBS full I still have enough room between it and...12 replies | 123 view(s) -
Yesterday, 10:45 PMi have never seen a sub mounted in the location i mentioned. i thought about moving one of my stereo batteries over there but David from earmark...12 replies | 123 view(s) -
Yesterday, 09:56 PMBeen outside working today and just not getting to really see what happened today in the OKC area. I have a few friends up there in OK and I know...8 replies | 78 view(s) -
Yesterday, 08:26 PMthere is actually a good amount of storage space in front of the drivers foot well accessible by removing the right bow cushion. you may be able to...12 replies | 123 view(s) -
Yesterday, 08:20 PMnice ride. maybe one day i will be in a position to custom order a new boat11 replies | 179 view(s) -
Yesterday, 08:18 PMThis almost makes me want to move north for a basement.... wait, ive been wakeboarding since february, never mind!97 replies | 2939 view(s) -
Yesterday, 02:21 PMrdlangston13 replied to a thread Where is your dripless Shaft Seal cooling water T'd in? in Service & RepairPictures??? Sent from my iPhone26 replies | 1368 view(s) -
Yesterday, 09:38 AMrdlangston13 replied to a thread Upgrading towers and amps... Exiled?? maybe... in Audio & ElectricalNo problems mounting xm7s with a z5. That's my set up and and you can adjust the z5 if clearance is an issue. Sent from my iPhone5 replies | 151 view(s) -
05-19-2013, 11:39 PMMy argument is not that cavitation is not bad for a pump, cavitation IS bad, I just do not see how a pump mounted directly at the fuel source could...22 replies | 423 view(s) -
05-19-2013, 10:53 PMwouldnt this happen to a pump that is not located in the tank too? i mean regardless of pump location in a sharp turn if the fuel gets away from the...22 replies | 423 view(s) -
05-19-2013, 07:53 PMHow shallow is it? And that sounds like the stock Gravity three on my boat. I had some buddies head out yesterday in a 2008 Supra Launch 21v...171 replies | 6270 view(s) -
05-19-2013, 04:02 PMNice video, you son can kill it. Wake weight and speed are you running to get the wake that consistent, it didnt even seem that the opposite side to...171 replies | 6270 view(s) -
05-19-2013, 01:41 PMI have the same issue, im probably going to have the tires swapped on the rims after this season5 replies | 98 view(s) -
05-19-2013, 12:18 AMI have heard multiple times on here that you should grease the steering cable or steering box at the rudder and that there is a grease fitting back...0 replies | 35 view(s) -
05-18-2013, 09:16 PMJust saw this when I walked outside. Not a Moomba but it does have underwater transom LEDs! Sent from my iPhone171 replies | 6270 view(s) -
05-18-2013, 09:02 PMwho needs a pool when you have a bayou??? hahaha81 replies | 1466 view(s) -
05-18-2013, 08:56 PMLiving Room from the living room looking into the office and hallway front of house81 replies | 1466 view(s) -
05-18-2013, 08:53 PMHeidi was kind enough to send me some pictures of todays updates! Enjoy! arch ways for the dining room and kitchen view of the kitchen and...81 replies | 1466 view(s) -
05-18-2013, 01:39 PMthat just seems odd those because until that line gets to the impeller isnt it under a vacuum kind of?23 replies | 300 view(s) -
05-18-2013, 12:50 PMso im pretty sure my dripless shaft cooling line comes from the hoses between the exhaust manifolds, it sounds like yall are saying this is wrong so...23 replies | 300 view(s) -
05-18-2013, 09:24 AMthat sounds pretty consistent171 replies | 6270 view(s) -
05-17-2013, 10:52 PMdepends on how many and what type of batteries. the 20 plus is a three bank charger and that is what i use since i run three batteries7 replies | 145 view(s) -
05-17-2013, 08:33 PMI just cant see my dealer charging that much for that repair. I have had much more work done for much less cost on my boat at my dealer edit:...23 replies | 300 view(s) -
05-17-2013, 08:32 PMPlywood under your drywall also helps dampen noise and ALSO proviodes a good base to hang things from without having to fine a stud81 replies | 1466 view(s) -
05-17-2013, 07:43 PMthis really costs $750 bucks to get done???? i had a motor mount replaced for cheaper than that!!23 replies | 300 view(s) -
05-17-2013, 05:42 PMuntil you want to run a wire we are done adding stuff, we have gone so far over our original budget it is unreal. the next house when we are not...81 replies | 1466 view(s) -
05-17-2013, 04:09 PMjust make sure the screw head is on the outside and the nut is on the inside. for looks....18 replies | 222 view(s) -
05-17-2013, 04:07 PMAH HA! Leave it to Ron to know the right answer! Stinkin EPA28 replies | 405 view(s)
5 Visitor Messages
About jdntexas
Basic Information
About jdntexas
- Location:
- Cypress, TX
- Interests:
- Baseball, Boating
Signature
Jerry
"Moomba Wanna Be'er"
Current boat - 2006 Yamaha SX210 w/New Dimension Tower & Cobra Jet Steering
TX Lakes - Somerville, Conroe, Fayette, Travis, Austin
"Moomba Wanna Be'er"
Current boat - 2006 Yamaha SX210 w/New Dimension Tower & Cobra Jet Steering
TX Lakes - Somerville, Conroe, Fayette, Travis, Austin
Statistics
Total Posts
- Total Posts
- 13
- Posts Per Day
- 0.05
Visitor Messages
- Total Messages
- 5
- Most Recent Message
- 10-10-2012 12:34 AM
General Information
- Last Activity
- 04-01-2013 09:40 PM
- Join Date
- 08-25-2012
- Referrals
- 0

