- Tab Content
- Hillbilly's Activity
- Visitor Messages
- About Me
-
Older Activity
-
05-07-2013, 12:23 PMI bought a roll of the thinnest I could find.......Hope it works.....lol3 replies | 106 view(s) -
05-07-2013, 12:21 PMI had removed the set screw it was just on there for so long I think it was a pain to get off.......But I got it!!!!! After pulling the V drive...16 replies | 378 view(s) -
05-05-2013, 08:39 PMSUNOFABISCUIT.......Ended up pulling the v-drive......Now does anybody happen to know a model # for a new gasket??? LOL This quickie job I...16 replies | 378 view(s) -
05-05-2013, 01:46 AMI got the nut off this evening then decided to pack it in for the night .......A few more steps and I will be 1/2 way done......lol16 replies | 378 view(s) -
05-04-2013, 05:48 PMLooks like the V drive might be coming out to get my coupler nut off. Anybody know what part # the gasket is between the v drive and trans? Or can I...3 replies | 106 view(s) -
05-04-2013, 11:33 AMCWB Marius is a great board and if you got the $ a DB9 is very light!! I've ridden the Marius shape for a long time and love it. The newest shape...13 replies | 321 view(s) -
05-04-2013, 11:13 AMI'm going to turn the shaft and see if the offset changes any as I turn the shaft and that should tell me right away if it's bent......Maybe it is...16 replies | 378 view(s) -
05-04-2013, 03:58 AMI spent a good couple hours trying to get my prop shaft coupler bolt out and could not get it to loosen? I was cranking on it both directions and...16 replies | 378 view(s)
1 Visitor Messages
About Hillbilly
Basic Information
About Hillbilly
- Biography:
- 07 LSV
- Location:
- NOR-CAL
Signature
07 LSV usually DUMPED
Statistics
Total Posts
- Total Posts
- 172
- Posts Per Day
- 0.10
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 06-04-2009 09:36 PM
General Information
- Last Activity
- 05-07-2013 02:49 PM
- Join Date
- 06-25-2008
- Referrals
- 0
