EarmarkMarine
Senior Member
Home Page
Find latest postsMini Statistics
- Join Date
- 05-08-2009
- Avatar
More 1 Friend
1 Groups
Join Groups 0 Permission Groups
You are not a member of any groups
- Tab Content
- EarmarkMarine's Activity
- Visitor Messages
- About Me
- Friends
- Tab Content
-
Older Activity
-
Yesterday, 11:09 PMK Riley, Thank you and that's always nice to hear. Odin, who I assume you dealt with and administrates the on-line store, can be a great help to...3 replies | 43 view(s)
-
06-18-2013, 08:46 PMThe trim function on an I/O and the wake plate function on a towboat are known to create a wicked transient through the audio system. The pump motor...8 replies | 116 view(s)
-
06-13-2013, 01:03 PMIt really works. I have it along with a handheld O-scope and they both display clipping at the same time so it is very accurate. The tool wll...17 replies | 250 view(s)
-
06-12-2013, 09:58 AMMaybe not....but at least they will look cool.47 replies | 1170 view(s)
-
06-11-2013, 11:47 AMOkay, think of a subwoofer enclosure as a finely tuned resonant chamber for a particualr woofer. Too large and it's flat and lifeless. Too small and...8 replies | 87 view(s)
-
06-11-2013, 11:35 AMI have seen the quicky tuning advice many times. At best they are very rough guidelines. And the over-simplified and abbreviated version is okay for...109 replies | 6136 view(s)
-
06-11-2013, 11:20 AMAll true. You will need no more than a 0.675 cu.ft. internal gross displacement for the right 10-inch sub. Some need even less. With .625"...8 replies | 87 view(s)
-
06-11-2013, 10:09 AMBass is going to be determined by surface area and enclosure displacment and power. The woofer is no larger than your fullrange speakers. The...8 replies | 87 view(s)
-
06-11-2013, 09:24 AMStacking those amplifiers one over the top of the other is not helping the thermal issues. Rotate them from horizontal to vertical side-by-side....109 replies | 6136 view(s)
-
06-08-2013, 11:56 AMThat's because Andy has been out of town and Barney has been spending alot of time with Aunt Bea.13 replies | 365 view(s)
-
06-07-2013, 06:36 PM"1. With the ZLD, if I turn the tower control down how is that affecting the amp? Voltage? Wattage? or is it just lowering the volume post amp? (i am...21 replies | 431 view(s)
-
06-07-2013, 12:12 PMThe OEM Kickers use a W-dome (hybrid dome/cone) that has always had an erratic treble response regardless of which manufacturer employed it. It's...21 replies | 431 view(s)
-
06-04-2013, 06:58 PMLewis, Okay, the speaker grounds are common to the RCA shield ground on most topologies. So if you have a grounded wire in the tower harness it can...10 replies | 229 view(s)
-
06-04-2013, 12:33 PMPAC LC-1. Don't just unplug the RCAs....short them from L to R. David10 replies | 229 view(s)
-
06-03-2013, 11:32 PMIf you want to fully eliminate the RCA cables as a potential noise magnet then unplug them from the amplifier and short the left and right RCA inputs...10 replies | 229 view(s)
-
05-31-2013, 08:50 PMLook at the bright side. Now you have nice passive radiator.13 replies | 365 view(s)
-
05-31-2013, 08:45 PMYou really can't do the 8 volt batteries because you have no practical way to charge them up to or maintain them at 16 plus volts. If you do not...20 replies | 414 view(s)
-
05-31-2013, 03:06 PMJD, Certainly all Class D amplifiers is the most important step to improve efficiency (that alone is a 60% improvement). Selecting the correct...8 replies | 153 view(s)
-
05-31-2013, 10:37 AMJD, Those things would certainly help. It's also important that the given alternator can produce sufficient amperage at the RPM that you operate....8 replies | 153 view(s)
-
05-29-2013, 01:19 PMJustin, A Perfect Pass is very voltage sensitive and is usually the first to act up. That's a normal sign of low voltage. Stereos, and pumps...8 replies | 153 view(s)
-
05-29-2013, 01:00 PMGrady, I don't know that amplifier. Check in the manual for the various status LED conditions. If you don't have the manual then do a search...13 replies | 365 view(s)
-
05-29-2013, 12:21 PMIf you equally apply the pressure on both sides of the cone as to not rock the cone, then you should not make any voice coil contact. Spread your...13 replies | 365 view(s)
-
05-29-2013, 11:03 AMGrady, If the sub is toast, the amplifier may only be in the protection mode. First, lightly and evenly push in on the center of the subwoofer...13 replies | 365 view(s)
-
05-28-2013, 10:57 PMHEY!*? I ressemble that remark....since I drive a Chevy truck with a Bose system.19 replies | 324 view(s)
-
05-28-2013, 09:55 PMThat would be true IF all the equipment is identical and IF the system you are emmulating is tuned optimumly in the first place. IMO, there is a...19 replies | 324 view(s)
-
05-28-2013, 09:32 PMThis is just my opinion, but I would not use the reduction of hiss as my prime objective in setting amplifier gains. My goal is to get the maximum...19 replies | 324 view(s)
-
05-28-2013, 09:41 AMLike Mike said, the tower zone gains will be set independent of the in-boat zone. Why? Because you want the tower to hit the sweet spot between low...19 replies | 324 view(s)
-
05-24-2013, 10:06 PMBoth components (resistor and inductor) are glued to the circuit board AND the leads are soldered through the circuit board. That is the norm. So I...20 replies | 531 view(s)
-
05-24-2013, 06:40 AMkreg, If the six in-boat coaxials are in a series/parallel scheme on two channels to keep the amplifier stable, then each in-boat coaxial is only...11 replies | 275 view(s)
-
05-22-2013, 11:14 PMThere is a big difference between a convertor that acts as regular power supply plus maintenance charger versus a basic battery charger. A charger is...3 replies | 158 view(s)
1 Visitor Messages
About EarmarkMarine
Basic Information
About EarmarkMarine
- Location:
- Dallas, TX
- Occupation:
- Marine Audio Specialist
Contact
Statistics
Total Posts
- Total Posts
- 850
- Posts Per Day
- 0.57
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 02-07-2012 06:09 PM
General Information
- Join Date
- 05-08-2009
- Referrals
- 1
