BSWAKE
Junior Member
Find latest postsMini Statistics
- Join Date
- 02-24-2010
- Last Activity
- 03-08-2010 09:02 PM
- Avatar
Recent Visitors
- 2007 Outback V,
- Andy L,
- aook23,
- Birdman_08_LSV,
- brdhami,
- cgriebs,
- Dealio,
- mndreamin,
- StephJones,
- trevormcfar
- Tab Content
- BSWAKE's Activity
- Visitor Messages
- About Me
- Friends
-
Older Activity
-
05-23-2013, 06:11 PMwoooo hooo I see the vaseline no no is slowly spreading23 replies | 260 view(s) -
05-22-2013, 08:54 PMdid you stabilize the fuel last fall and is the throttle in the neutral position, if its in the flooded engine position this will stop fuel from...12 replies | 116 view(s)
-
05-21-2013, 10:55 PMno, i gutted the place in 2006 so all is good, just wish i had of taken it off to the foundation4 replies | 91 view(s)
-
05-21-2013, 10:51 PMtrial n error....they discovered the problem in 2009 so some 09 have them that way and some do not. As far as i can figure.....just an oopsy25 replies | 411 view(s)
-
05-20-2013, 10:57 PMGot for a day this past weekend to resume photo by docdrs, on Flickr4 replies | 91 view(s)
-
05-20-2013, 10:56 PMDoing a washroom on the second level and wanted a little more room Untitled by docdrs, on Flickr Untitled by docdrs, on Flickr ...4 replies | 91 view(s)
-
05-20-2013, 02:11 PMsqueeg333 replied to a thread Where is your dripless Shaft Seal cooling water T'd in? in Service & RepairHmm, this thread has me thinking about doing what you just talked about Highrider. Might not be a bad move to change the location of the water...26 replies | 1390 view(s) -
05-18-2013, 10:12 AMThere are some good points in this thread. The vdrive does not have to be removed to install a dripless seal. What some mechanics say is aligned is...25 replies | 411 view(s)
-
05-17-2013, 04:48 PMThe dripless does not drip if its installed correctly and your alignment is within tolerances. So yes , why not have a dry bilge?25 replies | 411 view(s)
-
05-15-2013, 10:15 AMMaybe the new ignition switch is bad45 replies | 1475 view(s)
-
05-13-2013, 10:32 PMcheck your coupler bolts, look at your prop. let us know5 replies | 140 view(s)
-
05-10-2013, 04:01 PMKane, did you have to re-align your strut after you loosened it? When I pulled my prop shaft, I debated whether or not to loosen the strut. I was...16 replies | 380 view(s)
-
05-10-2013, 02:07 PMSolid, thanks guys. The more I think about it, the more I am sure that I have the pumps sitting identical to the original rule pumps - inlet is...13 replies | 275 view(s)
-
05-09-2013, 06:10 PMOkay, so what I am hearing is the outlet needs to be close to or on top of the pump body, but point in more or less a horizontal position? Am I...13 replies | 275 view(s)
-
05-07-2013, 02:40 PMHow bad is pulling the v-drive on these things? I looked at doing that a few years back to replace the strut bushings, but ended up pulling the...16 replies | 380 view(s)
-
05-07-2013, 12:33 PMJM - I did the same thing, vented the bags as well as put check valves on the vent lines and don't have much of an issue with water left in the bags...13 replies | 275 view(s)
-
05-06-2013, 07:30 PMThanks Daze, I think I saw a photo today of a similar setup to what I am looking for, and it looked like it worked out okay. They are on order so...25 replies | 1140 view(s)
-
05-06-2013, 07:20 PMI'd say about 70% of the time we go out, I have issues with my empty pumps on my ballast bags, more often than not the rear sacks. It seems they get...13 replies | 275 view(s)
-
05-06-2013, 05:48 PMAre the stock forks a Monster product, or did those come from another company? The forks on these Monster racks look very similar, not to mention...58 replies | 3715 view(s)
-
05-06-2013, 02:54 PMOh, I know exactly what they are, and want them because they are wake+surf racks. I don't want to mount them too much lower than Daze shows his...25 replies | 1140 view(s)
-
05-05-2013, 09:32 PMIs your throttle in the neutral position?10 replies | 244 view(s)
-
05-03-2013, 01:29 PMStupid question - has anyone used these racks in addition to the original factory ones? I'd love to get two of these racks, for the price it's a...25 replies | 1140 view(s)
-
05-02-2013, 02:29 PMIan, what brand of racks were those? I knew they were talked about on here a while back (at least I think those were them) and I really like em.217 replies | 8739 view(s)
-
05-01-2013, 04:18 PMI too have had great success with Bennett's customer service. They've sent me severl replacment parts for free. I had a leak from the upper hinge...11 replies | 497 view(s)
2 Visitor Messages
About BSWAKE
Basic Information
About BSWAKE
- Biography:
- Waiting for the ice to break so we can get back to what why we love summer so much!!
- Location:
- Lake Geneva, WI
- Interests:
- wakesurf, wakeboarding, hockey, boating, snowmobiling, relaxing with my family
- Occupation:
- Operator of www.bswake.com
Statistics
Total Posts
- Total Posts
- 12
- Posts Per Day
- 0.01
Visitor Messages
- Total Messages
- 2
- Most Recent Message
- 03-02-2010 10:51 AM
General Information
- Last Activity
- 03-08-2010 09:02 PM
- Join Date
- 02-24-2010
- Referrals
- 0
8 Friends
Showing Friends 1 to 8 of 8