- Tab Content
- loudsubz's Activity
- Visitor Messages
- About Me
- Friends
-
Older Activity
-
06-16-2013, 09:01 PMThat sounds much better. If they replaced it on summerization then they would have verified correct operation and all should be good. Will be...18 replies | 260 view(s) -
06-16-2013, 08:07 PMThis is so wrong, why would you ever load a new impeller over the winter.......put it in for summerization.....sorry, I just can't help myself when...18 replies | 260 view(s) -
06-16-2013, 12:38 PMIf the tstat is stuck closed then all the water will pass thru the tstat housing to the exhaust. If your exhaust cooling hoses are melted ,I would...18 replies | 260 view(s) -
06-12-2013, 11:42 PMyou can get the seals from OJ props or skidim. you have to determine if its the housing or the seal leaking. the cooling water line should be from...6 replies | 128 view(s) -
06-10-2013, 05:27 PMIf its a hot day could be the case. the heat in the engine compartment gets so hot that the fuel in the pump turns to vapour and an increased...6 replies | 94 view(s) -
06-09-2013, 10:13 PMloudsubz replied to a thread dam wakeboarders with loud music and not obeying the rules. in General Chatlol @ the comments about it being necessary to wakesurf I don't mind music, but for the most part you can be heard all over the lake unless you...15 replies | 576 view(s) -
06-09-2013, 05:17 PMIts the trailers fault ......you can tow your boat-less trailer with straps but should not drive your trailer-less tow boat with straps13 replies | 370 view(s) -
06-09-2013, 05:09 PMYou most likely have a regular shaft seal, unless it was upgraded after purchase, which can be tightened to reduce the leaking. It shouldn't vary...6 replies | 128 view(s) -
06-04-2013, 10:51 PMDOCDRS replied to a thread dam wakeboarders with loud music and not obeying the rules. in General Chatglad I live in canada where no one owns the water15 replies | 576 view(s) -
06-02-2013, 09:05 PMyou can always heat the hose with a torch an then snug it to get a perfect seal.......but anything before the impellar should not leak as its under...6 replies | 161 view(s) -
06-02-2013, 08:38 PMthanks, i finished p all the soffit and fascia this weekend, probably wont do the trim for a bit , but shes all bug and weather tight. Now i can...7 replies | 286 view(s) -
05-30-2013, 07:47 PMDOCDRS replied to a thread Cleaning threads of block drain ports and transmissions drain plugs in General ChatThat way they can justify a paltry to exorbitant summarization charge.10 replies | 237 view(s) -
05-30-2013, 06:31 PMloudsubz replied to a thread Cleaning threads of block drain ports and transmissions drain plugs in General ChatI didn't, dealer took out all the plugs and left them in the cup holder all winter. I only noticed when I went to go summerize the boat this year.10 replies | 237 view(s) -
05-30-2013, 04:44 PMIf its at the hull then you need to check you screws on the outside of the hull. you may be able to tighten them if they are loose or clean and...6 replies | 161 view(s) -
05-29-2013, 08:04 PMloudsubz replied to a thread Cleaning threads of block drain ports and transmissions drain plugs in General ChatAnyone know off the top of their head what size it is? 1/4" NPT?10 replies | 237 view(s) -
05-29-2013, 07:08 AMprice drop $2001 replies | 198 view(s) -
05-29-2013, 07:06 AMI was recommended the AC Delco MR43LTS Copper plug as an alternative to the IR plugs (expensive) in our 2010 LSV with Assault 325 (non catalytic). ...1 replies | 54 view(s) -
05-23-2013, 06:11 PMwoooo hooo I see the vaseline no no is slowly spreading24 replies | 497 view(s) -
05-22-2013, 08:54 PMdid you stabilize the fuel last fall and is the throttle in the neutral position, if its in the flooded engine position this will stop fuel from...17 replies | 276 view(s) -
05-21-2013, 11:17 PMI agree, but digital with the right DAC and source player can IMO sound just as good if no better (pops/clicks removed etc) I listen to a wide...103 replies | 3397 view(s) -
05-21-2013, 11:16 PMat first I was like "nice basement" after seeing the urinal I was like "amazing basement" :)103 replies | 3397 view(s) -
05-21-2013, 10:55 PMno, i gutted the place in 2006 so all is good, just wish i had of taken it off to the foundation7 replies | 286 view(s) -
05-21-2013, 10:51 PMtrial n error....they discovered the problem in 2009 so some 09 have them that way and some do not. As far as i can figure.....just an oopsy25 replies | 558 view(s) -
05-21-2013, 10:02 PMThat looks pretty good. Have there been any issues with older 325 engines from surfing?13 replies | 418 view(s) -
05-21-2013, 06:16 PMHow does this engine compare to the 325? Obvious is Obvious, more HP and Torque, but what makes it so special that it won some innovation awards etc?13 replies | 418 view(s) -
05-21-2013, 06:12 PMLet me know how the 3M stuff works. I have used the meguiars and worked ok but didn't get out all the marks I wish it had. I may try some 3M after...7 replies | 205 view(s) -
05-20-2013, 10:57 PMGot for a day this past weekend to resume photo by docdrs, on Flickr7 replies | 286 view(s) -
05-20-2013, 10:56 PMDoing a washroom on the second level and wanted a little more room Untitled by docdrs, on Flickr Untitled by docdrs, on Flickr ...7 replies | 286 view(s) -
05-19-2013, 09:04 PMThanks for responding, I knew it should be fused to protect the wire from over current so I couldn't figure out why they would skip it, but looked...3 replies | 163 view(s) -
05-19-2013, 08:51 PMNo combo just all black hull. I do have some deep scratches as well that I can see the white so I know I won't be able todo much to those with...3 replies | 134 view(s)
2 Visitor Messages
About loudsubz
Basic Information
About loudsubz
- Location:
- Muskoka, Ontario
- Occupation:
- Alarm Technician
Statistics
Total Posts
- Total Posts
- 368
- Posts Per Day
- 0.33
Visitor Messages
- Total Messages
- 2
- Most Recent Message
- 08-11-2011 07:42 PM
General Information
- Last Activity
- 06-09-2013 10:16 PM
- Join Date
- 05-29-2010
- Referrals
- 0
