Bodybou
Junior Member
Find latest postsMini Statistics
- Join Date
- 06-10-2010
- Last Activity
- 06-16-2013 06:13 PM
- Avatar
1 Groups
Join Groups 0 Permission Groups
You are not a member of any groups
Recent Visitors
- ABUCKOTOMAMBO,
- brain_rinse,
- deerfield,
- dmgx,
- GeauxTigers,
- Hootreville,
- StephJones,
- T100,
- WaterBullDawg1980,
- Wildbill
- Tab Content
- Bodybou's Activity
- About Me
-
Older Activity
-
06-06-2013, 09:47 AMAt the end of the steering wheel shaft on the housing you can see and feel the shaft move left or right when you turn the wheel slightly , you can...21 replies | 978 view(s) -
05-30-2013, 08:08 PMoil pressure sensor test good it goes out of limits when the ignition is turned on .4 replies | 55 view(s)
-
05-30-2013, 07:57 PMTo check the oil pressure sensor do i ground the single blue wire? The fuel pump works if i add power to it4 replies | 55 view(s)
-
05-30-2013, 07:31 PMOn the 05 outback ls for sale theres no power to the fuel pump ,when turning the key to start it will read 12.5 volts for a second then 0 even when...4 replies | 55 view(s)
-
05-25-2013, 06:42 PMComplete steering shaft assembly was just over 200$ here in Canada ,i did the job myself .21 replies | 978 view(s)
-
05-25-2013, 06:28 PMOk well im going to check all the conection and see if the sensor is still glued to the bottom of the boat .6 replies | 139 view(s)
-
05-25-2013, 11:28 AMSorry to hijack but what if it only reads this. ( -- ) its my 2012 , is the sensor no good or does something need to be done to get it to work6 replies | 139 view(s)
-
05-25-2013, 11:12 AMI had the same slop in my steering on my 05 outb, for mine it was the gear that drivers the cable comming from the steering wheel lower bushing worn...21 replies | 978 view(s)
-
05-25-2013, 10:06 AMThe 2012 indmar manual states the same,and ive been doing this for three years now with the same impeller that has over 300 hours on it and it still...24 replies | 500 view(s)
-
05-22-2013, 04:03 PMThank that helps a lot:)2 replies | 87 view(s)
-
05-22-2013, 02:42 PMHi all i installed the heater but I'm stumper on the 2 hot tube placements theres ether a steel support,electronic part or two step gelcoat finish in...2 replies | 87 view(s)
About Bodybou
Basic Information
- Date of Birth
- May 1, 1971 (42)
About Bodybou
- Location:
- Quebec, Canada
- Interests:
- Wakeboard, Wakesurf, having fun on the lake with friends
Signature
OBV 2008
Statistics
Total Posts
- Total Posts
- 6
- Posts Per Day
- 0.01
General Information
- Last Activity
- 06-16-2013 06:13 PM
- Join Date
- 06-10-2010
- Referrals
- 0