Search:

Type: Posts; User: supervol0509

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    192

    I'm just looking to replace the existing 6-1/2"...

    I'm just looking to replace the existing 6-1/2" speakers with new. There is an amp installed. I think it only has enough outputs to power the 4 tower speakers, and 4 of the cabin speakers. The two...
  2. Replies
    4
    Views
    192

    Speaker Replacement Questions

    I am looking to replace the inboard speakers on my boat during the offseason. I found another older thread discussing this, but some of the replacement recommendations are now discontinued. After...
  3. Replies
    5
    Views
    204

    When re-installing the knock sensor, is it...

    When re-installing the knock sensor, is it crucial for me to follow the steps in the engine manual (i.e. tighten to 168 in-lb, apply pipe sealant with Teflon to threads, checking for continuity, etc.)
  4. Replies
    5
    Views
    204

    The knock sensor does not drain the same...

    The knock sensor does not drain the same compartment as the starboard side drain plug? They drain different areas?
  5. Replies
    5
    Views
    204

    Winterization Questions

    I'm winterizing for the first time, and had a few questions:

    My engine block has a knock sensor on the port side. I removed the starboard engine block drain plug, and drained the water out. Is...
  6. Replies
    29
    Views
    1,107

    I'm Atlanta area, too. The place I spoke with is...

    I'm Atlanta area, too. The place I spoke with is doing fuel stabilizer, fogging, draining block, and repumping full of antifreeze for $99. Kind of want to learn how to do this myself, though. All...
  7. Replies
    29
    Views
    1,107

    Got it on the fuel filter, and I'll check it when...

    Got it on the fuel filter, and I'll check it when we put it in next Spring.

    As I said, I'm new to this, so I don't quite understand your antifreeze process. I imagine the water pump is made to...
  8. Replies
    29
    Views
    1,107

    Winterization & Maintenance Questions

    I've started my first winterization and maintenance process. Learning a lot, but still have a long way to go. Some questions:

    1. Replaces transmission and v-drive fluids last weekend. I found...
  9. Replies
    13
    Views
    363

    MLA, This has only occurred once we are out in...

    MLA,

    This has only occurred once we are out in the water, never off the trailer. I just bought the boat in March, and am not all that handy. Our first boat, too, so just trying to figure things...
  10. Replies
    13
    Views
    363

    JesseC, Do you have a part number for the...

    JesseC,

    Do you have a part number for the starter relay? It's worth a shot.
  11. Replies
    13
    Views
    363

    When we turn the ignition switch we aren't...

    When we turn the ignition switch we aren't getting anything. I don't hear anything, other than the beep and the fuel pump engage. I haven't stuck my head right down beside the starter, when trying...
  12. Replies
    13
    Views
    363

    I have nav lights tripping the breaker. This...

    I have nav lights tripping the breaker. This problem needs to be fixed, but is not urgent.

    The bigger problem is the intermittent operation of the starter. At times, it is not engaging. Other...
  13. Replies
    13
    Views
    363

    From everything I read, I am getting that...

    From everything I read, I am getting that everything is grounded to the engine block. Looks like the positive from the battery cable goes to the starter solenoid. I will have to trace the negative,...
  14. Replies
    13
    Views
    363

    Checking the grounding

    Can anyone give me a quick "How to" on this? We've had a couple of issues with our boat, and I'd like to check it out myself, but don't know where to start.
  15. Replies
    16
    Views
    570

    Found the starter. It is on the underside of the...

    Found the starter. It is on the underside of the engine. It is somewhat accessible from one of the storage bays. I cleaned the terminals for the wire from the battery, as well as whatever else...
  16. Replies
    16
    Views
    570

    I don't immediately see the starter. Any idea...

    I don't immediately see the starter. Any idea where it is?
  17. Replies
    16
    Views
    570

    There is no action out of the starter when it...

    There is no action out of the starter when it fails to engage. I've yet to start checking the ignition system for voltage or continuity. I will check the connecting wires.
  18. Replies
    16
    Views
    570

    Just wanted to post an update. We were still...

    Just wanted to post an update. We were still having issues, so I replaced the ignition switch a couple of weeks ago. The boat did great the day we changed the ignition switch. Started up every...
  19. Replies
    6
    Views
    235

    I will try to remember to take a picture this...

    I will try to remember to take a picture this weekend. As I said, the switch is toggled up. There is a plastic piece projecting out from the boat that says "RUN" on the top of it. The toggle...
  20. Replies
    6
    Views
    235

    Kill Switch Question

    My boat has a toggle kill switch beneath the throttle. The switch is currently toggled to the up position, so obviously the down position kills the boat. Should I have a lanyard or something...
  21. Replies
    16
    Views
    570

    They told me $30. I'm sure they will charge me...

    They told me $30. I'm sure they will charge me shipping if it is mailed or shipped. I live and work fairly close to Atlanta Marine, though, and may just go pick it up. I may do that just to talk...
  22. Replies
    16
    Views
    570

    Where am I installing this dielectric grease? At...

    Where am I installing this dielectric grease? At the wire connections? Do you have a link to what I need to use? I'd still like to replace the quick connect, unless there is more to it than I am...
  23. Replies
    16
    Views
    570

    Atlanta Marine had to order one. I guess they...

    Atlanta Marine had to order one. I guess they didn't have one lying around. I am in Atlanta, so it should be easy to get, once it is in.

    I found the way to hotwire the boat, doing the search. ...
  24. Replies
    16
    Views
    570

    Problems Starting Up (Cont'd)

    So, we took the boat to the Marina, and they could not get the boat to reproduce the issue we are experiencing on the lake. We took the boat out for the first time in three weeks today, and stopped...
  25. Replies
    25
    Views
    1,113

    Just to update everyone, my boat just needed an...

    Just to update everyone, my boat just needed an adjustment of the packing nut. The packing hadn't actually gone bad.
Results 1 to 25 of 46
Page 1 of 2 1 2