Search:

Hmm, this thread has me thinking about doing what you just talked about Highrider. Might not be a bad move to change the location of the water pickup from where it's located now (factory location). ...

Kane, did you have to re-align your strut after you loosened it? When I pulled my prop shaft, I debated whether or not to loosen the strut. I was really hesitant and didn't end up having to in the...

Solid, thanks guys. The more I think about it, the more I am sure that I have the pumps sitting identical to the original rule pumps - inlet is pointing stright up, and outlet is horizontal, but at...

Okay, so what I am hearing is the outlet needs to be close to or on top of the pump body, but point in more or less a horizontal position? Am I reading those comments right guys? If so, then yes, I...

How bad is pulling the v-drive on these things? I looked at doing that a few years back to replace the strut bushings, but ended up pulling the shaft out of the back of the boat. No issues really,...

JM - I did the same thing, vented the bags as well as put check valves on the vent lines and don't have much of an issue with water left in the bags once they do drain... it's just getting them TO...

Thanks Daze, I think I saw a photo today of a similar setup to what I am looking for, and it looked like it worked out okay. They are on order so I'll figure it out. Thanks!!

I'd say about 70% of the time we go out, I have issues with my empty pumps on my ballast bags, more often than not the rear sacks. It seems they get air locked often, and I have hassle with them to...

Are the stock forks a Monster product, or did those come from another company? The forks on these Monster racks look very similar, not to mention they are sized for the elongated oval bar that are...

Oh, I know exactly what they are, and want them because they are wake+surf racks. I don't want to mount them too much lower than Daze shows his being mounted because I want them higher than eye...

Stupid question - has anyone used these racks in addition to the original factory ones? I'd love to get two of these racks, for the price it's a hell of a deal, but I would still need a rack to put...

Ian, what brand of racks were those? I knew they were talked about on here a while back (at least I think those were them) and I really like em.

I too have had great success with Bennett's customer service. They've sent me severl replacment parts for free. I had a leak from the upper hinge on one of my actuators. It was leaking from around...

The remote is clutch in my opinion. It's great to be able to start and stop the camera at will while you're behind the boat. Not to mention you can change the mode of the camera from the remote. ...

I've had this happen too, though I am the second owner so I have no idea what was done cleaning wise before we got it. I have replaced several skins so far because of cracking, and I've got several...

You could just call SC and talk to them. I'm sure they could hook you up. Or call any local dealer. They should be able to have it drop shipped to your front door.

Where's the key at? I didn't see a key. Does it sense who you are, and when you sit down fires up? Now that would be sweet. Though in some instances could be an issue...

Anyone found a good place to buy the Gallon sized bottles of the stuff? I'm looking for a few different products from them, but curious if you guys have a go-to site for them.

Jokid, did you take care of this? I replaced my upper hinge that was leaking (Bennett sent me one for free) but it looks like I might still have a leak that I think is coming from the end of the...

Check thestarboard side wake plate actuator. Look in the engine compartment where the hydraulic lines feed the actuators, I believe the starboard side one will have a green wire coming thru the...

Go Vandals indeed!! Well played.

I found a slow leak of water coming from one side of my exhaust manifold. Found out my gasket was starting to go as well. Per Indmar, they only use the black hi-temp Permatex for the gasket, so if...

Those look good. The shims you had worked well I take it??

I was just going to ask this same question. My port side actuator is leaking from behind where it attaches to the boat (where the pipe nipple threads in). The photo attached shows it.
I emailed...

That's really a bummer Hawk, because the website says that each new accessory purchase comes with their set of Universal Collar Spacers. Maybe they don't consider a "blem" wakeboard rack to be an...