Search:

Hold on. I lost my confidence.

Back to the diagram. The ingition circuit breaker has two wires 1) Red and 2) Red/Violet. Since I ran the Red wire directly to the ignition switch....didn't just...

Folks, I may have just found sometnhing but I won't know until I get back to the lake.

I have reviewed my notes on my wiring of the new ignition and the wiring diagram. I have a red wire...

Check page three. The picture is near the bottom on the page. I don't know why they were spliced but I [too] thought it must be something to do with the keyless igintion cause i know it didn't come...

Check page three. The picture is near the bottom of the page. Thanks

parrothd,

Finally got back to the lake.

replaced the oil sensing unit. Still no luck. Everything remains the same. I get fire from the engine in start mode but engine dies when in "on" mode...

This sounds promising. It didn't know what to look for while I was at the lake this weekend. Makes sense.....I forgot to mention that I don't get the 12 volts to the fuel pump when the key is in...

Picture attached. Thanks
17029

17028
Hope this works.

I installed a standard key ignition and confirmed the wiring is correct. If I turn it all the way to start the engine fires and starts but i can't hold it in START long because I will ruin the...

Already installed a standard key ignition and confirmed the wiring is correct.

Thanks.

Bought from the person who purchased it at Atlanta Marine. I'm on Oconee. My problem is my trailer needs work and I don't have a vehicle to pull it with anyway.

[Can't see where this was posted. Apologies if re-posted]

Thanks to all for the suggestions!

Back from the lake. Problem remains. I don't have access to the internet at the lake so it...

Sensor, not gauge, correct? Located on engine?

Going up to lake this weekend. Will try this.

Thanks.

I did not solve my problem last fall so I'm back at it this weekend and hope to have some help from this forum. To add to my previous post I connected the fuel pump directly to the battery and it is...

OK, so that's the ECM? The 50 amp thing? Yes, I do have power to blower, radio, etc, so that is not my problem, right? i also put the volt meter to it and get 11.5 volts on it and the thing next...

I have the same problem as boat won't stay cranked. i have read this post and others so i will start in the middle. Please tell me if this is possible....



The fuel pump does not cycle when...