Search:

Thank that helps a lot:)

Hi all i installed the heater but I'm stumper on the 2 hot tube placements theres ether a steel support,electronic part or two step gelcoat finish in the way .

Does anyone have a pic or pics to...

Im going with the fuel pump or its unable to prime because its sucking air into the gas line when running .
Small air leak wont leak gas , usual colprit fitting and clamps .

My old Outback's mufflers were leaking i pached them with fiberglass resin mostly pin holes.

Why dont they still offer it ? Was there problems ?

my outback did that especially when accelerating from a tern, seemed to do it only when rudder was turned when power is applied .Greasing ruder will remove most of the vibes going to the steering...

The H3 with 1 euro vent 2 hot tubes

The circulation pump doesn't have enough flow & volume of water at idle to supply hot water to the heater (LSV) your theory of adding a Y before raw water will work marginally adding a booster pump...

Before you make a choice a good point to check is the adjustment to the legs and pin location , some company's put the pin at the very bottom of the frame a pain in the a&$ when water is cold for...

Cool thanks

Hi all I'm ordering a heater from heatercraft ,The question is do i need a (booster pump)and is the best place to instal the heater behind the panel under dash .

2012 LSV

Looks like the boat won't pas 1500 rpm when hot hard to tell from video.
If you have a water strainer be sure the fittings don't twist it will pull in air .

This is what happen to my LS

Looks like the boat won't pas 1500 rpm when hot hard to tell from video.
If you have a water strainer be sure the fittings don't twist it will pull in air .

New boat 4 days old


15699

deafgoose the price they gave you seams about right for this time of year (to low for me )in the spring you would get more for the boat. You should have no problem selling for 35'000 to 40'000...

Check all connections battery,starter,grounds if that's all good you may need a battery the old one has voltage but not enough amps.

I,m finally at 180 this year

I will change sides time to time surfing goofy with ballast reg with passengers reg side the wave seems to be longer but a little washed more fun if you want to hang further back, must be a prop...

Try surfing standing backwards heals to the front it's actuly very hard to do , I also tried for a vary long time to do a hand stand no avail.

Mine doesn't burn any oil not a drop well maybe but not enough to sea a difference .

The way you described your setup is a good starting point ,adding weight on the fuel tank is not a good idea ,
My setup front ski locker sack half rear hard balast full 400 on floor behind engine to...

I had an overheating problem boat would heat up on idle my new impeller would only last 40 hours caused by an air leak at the strainer if you see air bubbles in the strainer it's pulling air from...

If your going with the 13-13-1 in Left rotation 4 blade you can't wrong.

Higher than normal oil pressure is usually caused by a stuck pressure relief valve in the oil pump assembly.

It could be any three
Test or bypass safety switch ,on back of ignition switch check for power on solenoid wire ( would be marked with an S or SOL )

When turning the ignition switch check for...