Search:

Type: Posts; User: jzelt

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    35
    Views
    1,097

    Ours is the Launch. Updated signature as well....

    Ours is the Launch. Updated signature as well. Thanks for asking.
  2. Replies
    35
    Views
    1,097

    We have 04 Supra 22 SSV. We love it. Just bought...

    We have 04 Supra 22 SSV. We love it. Just bought a Surf board for it but haven't used it yet, wakeboard, and mostly slalom ski with a 3 yr old (yesterday his birthday) with a trainer ski, tube,...
  3. Replies
    9
    Views
    160

    This is what I have for 2004. When our fuel pump...

    This is what I have for 2004.
    When our fuel pump went, it wouldn't work even directly wired to a battery.
    Replaced with new pump and still no power. Replaced relays, then took it to a dealer...
  4. Replies
    3
    Views
    80

    Also if you need to re-order the sending unit,...

    Also if you need to re-order the sending unit, make sure you measure the tank depth. When I did, the old unit always said that it was empty when it was 1/2 a tank. Then new unit is very accurate....
  5. Replies
    20
    Views
    421

    Same "boat". I used silicon sealant and filled...

    Same "boat". I used silicon sealant and filled once. (this is our spare bag) and we don't fill it totally full, and the valve like that I made the top so it doesn't have as much weight on it all the...
  6. Thread: New board help

    by jzelt
    Replies
    13
    Views
    474

    Jump forward in the air, and see where and how...

    Jump forward in the air, and see where and how your feet are positioned when you land and set your bindings similar.
  7. Thread: Bilge Question

    by jzelt
    Replies
    25
    Views
    887

    I have never done it, but I would be inclined to...

    I have never done it, but I would be inclined to use some dish soap on the drive shaft to lubricate it so it slid easier thru the seal. (No delicate way to word what I am trying to say, but it goes...
  8. Replies
    16
    Views
    388

    Second Trayson's list. Small tool kit like his...

    Second Trayson's list.
    Small tool kit like his that fits in the cubby hole. Was my nicest tool set for a while...

    Plumber wrench with handle shortented to tighten the packing nut....
  9. Replies
    4
    Views
    180

    ^^^Exactly. Fried with Straub beer or butter....

    ^^^Exactly. Fried with Straub beer or butter.
    Venison (Deer) is pretty dry, so we make dumplings with that ground up.
  10. Thread: Bilge Question

    by jzelt
    Replies
    25
    Views
    887

    It would drip from the packing nut. If you have...

    It would drip from the packing nut. If you have water to the bottom of that, then you aren't going to see it drip. (Try getting everyone to the bow to move the water out of the way. It is supposed to...
  11. Replies
    14
    Views
    556

    Sticky: I agree, I tighten the nut with channel locks...

    I agree, I tighten the nut with channel locks till it is pretty tight, back it off a ways, then hand tighten to where the cotter pin will go thru.
  12. Replies
    2
    Views
    120

    I use mothers mag and aluminum polish. Put some...

    I use mothers mag and aluminum polish. Put some on the tubing, then take a rag and wrap it around once and pull it back and forth like the "old" fire starting with a stick method, back and forth.
  13. Replies
    4
    Views
    149

    What I think you should do (what I would do in...

    What I think you should do (what I would do in your position) is
    a) prop your seats when done boating for the day so they can dry out the foam,
    b) pay attention to how it sits in the water when...
  14. Replies
    41
    Views
    2,009

    Sounds like there might be a short in the switch...

    Sounds like there might be a short in the switch or wiring since it is sporadic?
  15. Replies
    11
    Views
    374

    Try cleaning ground wires, connections to...

    Try cleaning ground wires, connections to injector. Had a snowmobile act up this winter, they replaced ECM, same issue, then went thru all wire connections and walla...
    I did replace the throttle...
  16. Replies
    6
    Views
    312

    You could also use a oil pump syphon (nondrill)...

    You could also use a oil pump syphon (nondrill) and go thru the fuel gauge sendor hole and syphon out the tank than run it thru the pump...
  17. Replies
    6
    Views
    306

    Ours is 40-60 with straight 40 weight oil.

    Ours is 40-60 with straight 40 weight oil.
  18. Replies
    16
    Views
    493

    I would also ask if you fuel tank is full at the...

    I would also ask if you fuel tank is full at the beginning, but after running for a while, does it reach a level that it isn't able to pick up any more until you even it out by emptying the tank...
  19. Replies
    3
    Views
    134

    A fuel gauge that threads on the shrader valve...

    A fuel gauge that threads on the shrader valve will be very helpful for you to diagnose (I bought one for just such issues), there are a few threads popping up of issues going on with fuel pumps/fuse...
  20. Thread: Ski Pics

    by jzelt
    Replies
    26
    Views
    1,729

    They make slalom ski trainer ropes w a triangle...

    They make slalom ski trainer ropes w a triangle in front of the handle you would put the ski tip in to help hold it vertical.
    Others also start by dragging their back foot out of the ski (like...
  21. Thread: Ski Pics

    by jzelt
    Replies
    26
    Views
    1,729

    If you try deep water start, take a deep breath...

    If you try deep water start, take a deep breath hide behind the ski and hold on tight.
    It is the hardest you will ever have to fight to get out.
    I say gear and the driver puts it in idle.
    This...
  22. Thread: Boat flag pole?

    by jzelt
    Replies
    14
    Views
    766

    I use pvc and slide it over the back middle wake...

    I use pvc and slide it over the back middle wake board rack post. Then a board goes above and below it w USA flag on each side.
  23. Replies
    6
    Views
    363

    Hose clogged? You can disconnect both end and...

    Hose clogged? You can disconnect both end and blow into it. (suggest putting paper towel around fitting where mouth would go).
  24. Replies
    21
    Views
    676

    Awesome. For those with towers, we bought a king...

    Awesome.
    For those with towers, we bought a king sized bed sheet and hang it from the tower and run a corner to each cleat (bow or stern) with the blue tarp clips from lowes (which sink, but are...
  25. Replies
    21
    Views
    676

    Yep. Congrats. The first several nights were the...

    Yep. Congrats.
    The first several nights were the best sleep. It is a few days later they get their attitudes'.

    Enjoy and be thankful every day no matter how many buttons they push.
    2 1/2 yrs...
Results 1 to 25 of 46
Page 1 of 2 1 2