Search:

Type: Posts; User: MLA

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    4
    Views
    60

    Yes it sure does. If you are in tune with the...

    Yes it sure does. If you are in tune with the wave, you can actually tell when you go over a shallow spot.
  2. Thread: Electrical Gremlin

    by MLA
    Replies
    1
    Views
    49

    I would diagnose these 2 issue independently of...

    I would diagnose these 2 issue independently of each other. Just seems like a coincident.

    For a breaker or fuse to trip/pop, there needs to be a short to ground or over current between the...
  3. Replies
    18
    Views
    401

    Just change the position of the sub input button...

    Just change the position of the sub input button on the amp. The sub will then receive its signal from the full-range inputs that feed chnls 1-4.
  4. Replies
    18
    Views
    401

    Off or full-range or something higher then 150HZ

    Off or full-range or something higher then 150HZ
  5. Replies
    18
    Views
    401

    The access door on the KXM amp is held closed by...

    The access door on the KXM amp is held closed by two allen head screws.

    Just for chits and giggles, change the position of the sub input button. Lets get its signal from the other RCA's. If that...
  6. Replies
    18
    Views
    401

    Is this regarding your amp, or the pic of Jason's...

    Is this regarding your amp, or the pic of Jason's amp? For the amp pictured above, Input Level = Hi/Low is to se the amp depending on the source level, like speaker outputs or RCA's. FADE OFF when...
  7. Replies
    18
    Views
    401

    Ok, so the sub level knob turns the sub up and...

    Ok, so the sub level knob turns the sub up and down, its just that when all the way, its output is still lacking.

    That sub absolutely will perform 10X better, with a small sealed enclosure...
  8. Thread: bags not emptying

    by MLA
    Replies
    4
    Views
    127

    Are these being manually filled and drained with...

    Are these being manually filled and drained with a W709 pump kit, piggy backed on to the factory setup, did they replace a hard tank that was in the locker or did you do a ground up custom ballast...
  9. Replies
    18
    Views
    401

    Ok, its safe to say that the system was not tuned...

    Ok, its safe to say that the system was not tuned with knob in mind. Just to make sure every thing is working like it should, turn the sub knob all the way, turn the head-unit volume up to 75%, place...
  10. Replies
    18
    Views
    401

    Jason, You said you attached the bass level...

    Jason,

    You said you attached the bass level knob. What it supplied with the boat, and just not plugged up?

    What sub is there?
  11. Replies
    4
    Views
    162

    One thing to consider with a product like a...

    One thing to consider with a product like a Dynamat, is reducing the volume of an already small pod. This reduces the mid-bass.
  12. Replies
    5
    Views
    181

    If all you have is soft bags, including the IBS,...

    If all you have is soft bags, including the IBS, with quick disconnects, theres not much left to do. Run some Marine/RV pink antifreeze where you feel you need to, but i do not see where any water...
  13. Replies
    7
    Views
    234

    There has been a single pipe FAE for Tige since...

    There has been a single pipe FAE for Tige since they went to PCM in 09. Clears the TAPS plate, no problem.
  14. Replies
    14
    Views
    372

    Without reading the documentation from SC...

    Without reading the documentation from SC specifically regarding the Flow, I cant say specifically. My comments are general about owners doing work. In most states, there are statutes that prevent a...
  15. Replies
    14
    Views
    372

    A franchise Dealer can void a warranty just a...

    A franchise Dealer can void a warranty just a quick as an owner can. Warranty is backed by manufacturer, not dealer. Dealer just agrees to do work at a set price and get reimbursed. Manufacturer is...
  16. Thread: Electrical whine

    by MLA
    Replies
    19
    Views
    434

    Ok, so the main gain is fixed, but the noise is...

    Ok, so the main gain is fixed, but the noise is when the EQ is in either main or AUX modes? That puts it on the output side and would make sense if its heard in both the front and rear zones, since...
  17. Thread: Electrical whine

    by MLA
    Replies
    19
    Views
    434

    Does the EQ have adjustable input sensitivity? If...

    Does the EQ have adjustable input sensitivity? If so, how is it and the amp gains set? Higher the gains, the more the system is open to unwanted noise.
  18. Replies
    10
    Views
    233

    Never sold/installed one, but the couple i have...

    Never sold/installed one, but the couple i have heard, both self powered and non-powered, and they are kinda a 1-note wonder subs in terms of SQ. If it fits the spot and fits the budget and you are...
  19. Thread: Electrical whine

    by MLA
    Replies
    19
    Views
    434

    Boon, You easily bypass the head-unit and...

    Boon,

    You easily bypass the head-unit and trigger the amps on directly. Use the red switched 12 that triggers the head-unit now, to trigger your relay that would supply the 12v trigger to the...
  20. Replies
    10
    Views
    363

    Besides consulting the manufacturer on whats a...

    Besides consulting the manufacturer on whats a safe cleaner to use, I have had great success with Dura-Gloss #541 Marine & RV Mildew Buster.
  21. Thread: Electrical whine

    by MLA
    Replies
    19
    Views
    434

    Give us some additional details about the system....

    Give us some additional details about the system. Try running RCA direct from head-unit to sub amp.
  22. Thread: Major Audio Issues

    by MLA
    Replies
    5
    Views
    234

    Sam, It certainly sounds like you have a few...

    Sam,

    It certainly sounds like you have a few issues, one compounding on another. Any failed or defective OEM installed components would need to be dealt with through your Moomba dealer. Any...
  23. Replies
    16
    Views
    285

    If the wear is fairly even left and right and...

    If the wear is fairly even left and right and inboard to outboard, then i would look upstream to the main lines and coupler. Make sure the short hose between the trailer and folding tongue is not...
  24. Replies
    16
    Views
    285

    Do you have a pic of the outboard pad? Mainly...

    Do you have a pic of the outboard pad? Mainly interested in its thickness compared to the inboard pad. Also, how does the suspect sides pad thickness compare to the other side?

    There will always...
  25. Replies
    11
    Views
    235

    Nothing factory about 3 batteries. But, it could...

    Nothing factory about 3 batteries. But, it could be the original configuration with a 2nd house battery wired in parallel. Bu then again, could be two 6V GC's wired in series.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4