Search:

Type: Posts; User: Engine Nut

Page 1 of 6 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    4
    Views
    145

    The procedure does say it is best done with the...

    The procedure does say it is best done with the boat in the water although even when not in the water, the transmission spins and pumps oil whenever the engine is running.

    Someone made the...
  2. Replies
    4
    Views
    145

    Checking Transmission Fluid

    Here is the correct procedure for checking transmission fluid in the shifting portion of your v-drive or in an in-line transmission. It applies to Indmar V-drive, Velvet-Drive and ZF transmissions....
  3. Replies
    14
    Views
    937

    If you are rebuilding the engine and have it...

    If you are rebuilding the engine and have it taken apart, you should be able to see if the engine uses a conventional timing chain or does it use timing gears. Typically right hand rotation engines...
  4. Replies
    5
    Views
    668

    Who is ultimately going to back the warranty on...

    Who is ultimately going to back the warranty on the engine? I would follow the procedure that they recommend.
  5. Replies
    10
    Views
    1,840

    Running at that RPM for extended times should not...

    Running at that RPM for extended times should not be an issue as long as the engine is able to operate within the designated RPM range at wide open throttle.
  6. Replies
    10
    Views
    1,840

    MPI means Multi Port Injected. The WOT rpm for...

    MPI means Multi Port Injected. The WOT rpm for your engine is 4600-4800. Your manual says 4600-5200 but the high end of the range for your engine is 4800.
  7. Replies
    10
    Views
    1,840

    We have never tested the FAE system so I have no...

    We have never tested the FAE system so I have no factual data. I would have one concern that since the exhaust is expelled under the surface of the water that the exhaust back-pressure when the boat...
  8. Replies
    5
    Views
    3,606

    Sticky: Don't Kill Your Engine!

    If you wakeboard or wake surf and load your boat heavily it is critical that your boat is propped appropriately to ensure that your engine gives you the kind of life that you expect. It is critical...
  9. Replies
    10
    Views
    1,840

    Don't Kill Your Engine!

    If you wakeboard or wake surf and load your boat heavily it is critical that your boat is propped appropriately to ensure that your engine gives you the kind of life that you expect. It is critical...
  10. Replies
    15
    Views
    884

    That 70A alternator is Indmar P/N 575010. You can...

    That 70A alternator is Indmar P/N 575010. You can get one from inboardonline.com. Better price than skidim.
  11. Replies
    25
    Views
    11,233

    Sticky: That article was based on data from an LSA engine...

    That article was based on data from an LSA engine which is our supercharged small block engine. That engine uses Mobil 1 fully synthetic 5W30 oil as specified by General Motors. The data is...
  12. Replies
    2
    Views
    478

    Get the solenoid for the 4 wire PG260 starter.

    Get the solenoid for the 4 wire PG260 starter.
  13. Replies
    10
    Views
    1,426

    Did you look in your engine Operator's Manual?...

    Did you look in your engine Operator's Manual? All that information is there. If you don't have one, here is a link.

    ftp://ftp2.indmar.us/Manuals/Operator's%20Manuals/2006%20Operator's%20Manual.pdf
  14. Replies
    7
    Views
    1,043

    Your engine actually has two fuel pumps. That...

    Your engine actually has two fuel pumps. That part with the filter under it is the high pressure pump and the other one is a high volume low pressure pump that draws fuel from the tank and feeds the...
  15. Replies
    7
    Views
    1,043

    Here is a link that will take you to a diagram ...

    Here is a link that will take you to a diagram that I believe will apply to your engine.
    ...
  16. Thread: oil change

    by Engine Nut
    Replies
    12
    Views
    1,114

    Shell Rotella 15W40 is very good choice.

    Shell Rotella 15W40 is very good choice.
  17. Replies
    5
    Views
    481

    the drain plug is an 1/8 NPT brass pipe plug.

    the drain plug is an 1/8 NPT brass pipe plug.
  18. Replies
    16
    Views
    1,686

    The 11 foot pound torque is for the intake...

    The 11 foot pound torque is for the intake manifold, not exhaust. Using a gasket is OK but the RTV works very well. We have been building engines that way for the past 30 years or so. There is no...
  19. Could be the drive plate that bolts to the...

    Could be the drive plate that bolts to the flyheel. The center portion where the input shaft of the transmission plugs in has springs to absorb the torque when shifting into gear. If one or more of...
  20. Replies
    6
    Views
    645

    The Indmar P/N Is S605030.

    The Indmar P/N Is S605030.
  21. Replies
    15
    Views
    1,788

    EFI engines work like that but not carbureted...

    EFI engines work like that but not carbureted engines. Carbureted engines have fuel pump safety switches like I described.
  22. Replies
    15
    Views
    1,788

    The fuel pump should not run with the key in the...

    The fuel pump should not run with the key in the on position. There is a fuel pump safety switch near the distributor that should only allow the pump to run when the engine is either cranking to try...
  23. Replies
    11
    Views
    1,274

    They don't really get dirty ... not too much...

    They don't really get dirty ... not too much dust/dirt on the water. A cleaning once a year is recommended.
  24. Replies
    11
    Views
    1,274

    Doesit look like this one? That flame arrestor...

    Doesit look like this one? That flame arrestor has more air fow capacity than your engine really needs. You can clean it with carb cleaner or even soap and waer and a brush. Just make sure it is dry...
  25. Replies
    11
    Views
    1,274

    What model engine do you have? Most Indmar...

    What model engine do you have? Most Indmar engines already have K&N Flame Arrestors. If yours looks like this it is a K&N. You need to make sure that if you install any flame arrestor that is...
Results 1 to 25 of 147
Page 1 of 6 1 2 3 4