Search:

Type: Posts; User: WolfpackRider

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    23
    Views
    1,849

    It's kind of hard to say for sure since it was...

    It's kind of hard to say for sure since it was not a problem I could regularly repeat, but I think those that suggested vapor lock were right. If that was the problem, I think it must have been...
  2. Replies
    23
    Views
    1,849

    I definitely agree that it is fuel related! ...

    I definitely agree that it is fuel related!



    I'm going to start by replacing the fuel filter. I might go ahead and get a fuel pump to have ready.



    The butterfly valve is opening when I...
  3. Replies
    23
    Views
    1,849

    2nd video of fuel pump: ...

    2nd video of fuel pump:


    http://www.youtube.com/watch?v=G7cuYoquQOg
  4. Replies
    23
    Views
    1,849

    We had the problem again today. I took a few...

    We had the problem again today. I took a few videos. The first one was taken while the engine was running making the sound. I had the flame arrester off. So, it was a little louder, but not much. I...
  5. Replies
    23
    Views
    1,849

    Hmm, now that's a possibility. :D It's a good...

    Hmm, now that's a possibility. :D It's a good thing it stopped!
  6. Replies
    23
    Views
    1,849

    It definitely was not the bilge pump. I've...

    It definitely was not the bilge pump.

    I've never had a vapor lock problem before. The lake and air temps were around 75, which makes me think that wasn't the problem. Can vapor lock cause that...
  7. Replies
    23
    Views
    1,849

    Air sucking sound/stall?

    Today was our first day out this year. The boat ran great for a few hours. We stopped for a bit to let the kids swim and have a snack. When I started it back up, there was a strange air sucking sound...
  8. Replies
    8
    Views
    868

    As a followup, I installed a KMR-350U last night...

    As a followup, I installed a KMR-350U last night and the Aeware remote worked correctly when attached to the wire labeled as the steering wheel remote wire.
  9. Replies
    8
    Views
    868

    So, I can't use the Aeware remote without also...

    So, I can't use the Aeware remote without also getting a new remote that I would connect the Aeware one to using the butt connectors?
  10. Replies
    8
    Views
    868

    So, would I connect the signal wire from the...

    So, would I connect the signal wire from the Aeware remote to the wire from the wiring harness labeled as "Remote"?
  11. Replies
    8
    Views
    868

    KMR-350U and aeware remote

    I need to get a new HU. I'm thinking to get a KMR-350U because I've seen that it is compatible with the Aeware remote that came installed in my boat (2005 Mobius LSV). However, my current unit...
  12. Replies
    7
    Views
    580

    Those are the ones! Thanks!

    Those are the ones! Thanks!
  13. Replies
    7
    Views
    580

    Unfortunately, I already threw them away.

    Unfortunately, I already threw them away.
  14. Replies
    7
    Views
    580

    LSV locker support screw anchors

    I'm getting the upholstery on my LSV locker tops and engine cover replaced by a neighbor. I took some of the upholstery off of one of the lockers. I had a problem removing some of the screws that...
  15. looking for deal on new wakeboard mainline

    I'm looking for a new mainline that's a little longer that what I have. I'm seeing some great deals on the Gator Boards Vandal 80' Mainline that is black/red and made from Dyneema. Any...
  16. Make sure to test the spot before gluing!! I...

    Make sure to test the spot before gluing!! I cleaned the surface really well (wiped off everything that came up, then degreaser, then alcohol) and then epoxied it down. Unfortunately, I didn't...
  17. Replies
    25
    Views
    2,114

    Wow - bummer of a burn - good to hear it's...

    Wow - bummer of a burn - good to hear it's healing up okay.

    How are you supposed to go about replacing the light? I was tracing out some of the wiring recently and could not even touch the light...
  18. Replies
    4
    Views
    1,098

    I agree on pulling the floor. It's really not...

    I agree on pulling the floor. It's really not too bad (though much easier with someone to help you). Make sure you remove the screws that go in from the side that are under the seats. Also, turn...
  19. need part number for starter solenoid

    My engine only cranks every 7th try or so. It always clicks but doesn't always turn over. Jumping the solenoid posts makes it crank when it is having trouble. I'm pretty certain the contacts in...
  20. Yes, I was running on a fake a lake both times. I...

    Yes, I was running on a fake a lake both times. I had plans on extracting it after our last trip out this year, but the "last trip" never happened. I do run it a little faster than idle with the...
  21. In my experience, it's all about getting your...

    In my experience, it's all about getting your engine warmed up enough. Last year I changed it when it was fairly cold outside (maybe mid 40s?). I ran the engine until the temp gauge showed it was...
  22. Replies
    2
    Views
    337

    I had my cable get so tight that I had to steer...

    I had my cable get so tight that I had to steer with both hands. I ordered a new cable through my dealer and replaced it myself. It was a fairly easy job. If you do it, make sure you turn your...
  23. Dirty starter - replacement brushes?

    I was going to post this in another thread, but I can't find it with the new search problems.

    I had my first no-go at the lake a few weeks ago. It acted like a weak battery - I'd get a click and...
  24. Replies
    6
    Views
    747

    I fixed the leaking hose and put on a Gates belt....

    I fixed the leaking hose and put on a Gates belt. I've put around 25 hours on the boat since then and haven't had any more problems breaking the belt. So, I'm thinking it was the fact that it was...
  25. Replies
    5
    Views
    296

    Wow, I think mine just went out a few weeks ago...

    Wow, I think mine just went out a few weeks ago as well. I still haven't verified that it is definitely the pump, but my switch is still good, and I don't have any blown fuses ('05 Mobius LSV).
Results 1 to 25 of 41
Page 1 of 2 1 2