Search:

Type: Posts; User: cfdrews12

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    6
    Views
    206

    Newty has two great checks that are easiest and...

    Newty has two great checks that are easiest and usually the cause of the issue. Pretty hard to hook up the battery cables incorrectly if your paying attention, however, I did have a similar issue...
  2. Replies
    10
    Views
    186

    I've got a 2004 Outback. when skiing hard,...

    I've got a 2004 Outback. when skiing hard, wakeboarding or surfing, we burn in the 7 gallons an hour range just to confirm your numbers. If the boat is not missing or running rough, then you may...
  3. Replies
    17
    Views
    490

    Ok, I'm going to throw everyone a curve ball...

    Ok,

    I'm going to throw everyone a curve ball based on recent research I've done. I've been on lots of Mastercraft, Supra, and Malibu forums lately because I've got to get some of my Vinyl...
  4. Replies
    14
    Views
    1,413

    i've tried multiple failed attempts, and are...

    i've tried multiple failed attempts, and are looking to do yet something different this year. While I still have my batteries and my amp installed on the port wall, tucked in and around the corner,...
  5. Replies
    14
    Views
    1,959

    One other option. Harbor Freight sells some...

    One other option. Harbor Freight sells some standard pullers (3 and 4 fork) in a package that works awesome. Around $25 bucks if I remember correctly in a 3 pack (small, med, large). Works...
  6. Replies
    9
    Views
    829

    Just replace the cable. I tried all the same...

    Just replace the cable. I tried all the same "defensive" things that you also have done but eventually the answer is to bite the bullet and replace the cable. I did this 1 season ago and the joy of...
  7. Replies
    2
    Views
    420

    If you've checked the fuse, also check and clean...

    If you've checked the fuse, also check and clean the connections on the back of the switch. They can get junked up over time and simply not having a good connection when you flip the switch means no...
  8. Replies
    8
    Views
    847

    Yes. You can also take it completely apart and...

    Yes. You can also take it completely apart and find out if you got a bind some where. When I installed a new steering cable last year, I grabbed the bar by hand where it connects. It actually was...
  9. Replies
    21
    Views
    2,154

    Also, need to check to see the pumps are working...

    Also, need to check to see the pumps are working correctly or engaging when you flip the switch. I found that in some cases my pumps were not working properly because of no electric connection from...
  10. Replies
    16
    Views
    1,995

    So Vandy, good riding with you this weekend. ...

    So Vandy, good riding with you this weekend. Reading your thread reminded me that you don't have your throttle cable zip tied. When we were looking at your engine and doing the head scratching, I...
  11. Replies
    4
    Views
    1,245

    Just to confirm from my last year experience: ...

    Just to confirm from my last year experience:

    1) Pull the floor. The cables are zip tied and you can do some damage to other tubing and items that also run under the floor by pulling via a rope...
  12. Replies
    8
    Views
    1,530

    Flush Kit

    Does this cause the impeller to burn out? This looks like it by passes the impeller. I can't tell from the picture, maybe you installed it just after the strainer up from the raw water intake and...
  13. Replies
    15
    Views
    961

    Vinyl Rip

    I've used a product you can get at Overtons or Amazon.com called Tear-Aid. Small holes or tears can be covered with this and get you through the season until you want to get them repaired or fixed....
  14. Replies
    5
    Views
    667

    LSV Steering Cable

    Did you find the part number for the LSV Steering Cable Replacement? I've unhooked mine from Rudder (pain to reach but easy) and have loosened the 4 bolts that hold the cable shaft tight in back
    ...
  15. Replies
    14
    Views
    6,084

    Solved

    OK. Just information back to the group in case you run into this and didn't think to try it out.

    #1. I've learned to take out my starter and put it back in in under an hour. Remarkable but...
  16. Replies
    10
    Views
    987

    Boat Starting Issues

    So I'm jumping over to this thread because I'm experiencing same type of issues and can't figure it out. Thanks gcnetti for taking the time to be part of thread. So here is what I've done to try...
  17. Replies
    14
    Views
    6,084

    Starting

    So I appreciate all the help. So far this is what I've done. I've checked the resistance on the power cable that goes between battery and Starter. 1.3, so I assume this means cable is still good. ...
  18. Replies
    14
    Views
    6,084

    Sounds same as my no-start trouble.

    So I'm on the lake and can't get the boat to start. Same clicking that everyone in this thread talked about. But only clicking, time and time again. So hooked up another battery and jumped the...
  19. Replies
    21
    Views
    1,923

    Speakers

    Noticed the re-post. Give me the details:

    Looks like they are in good shape. Any issues with them?
    Did you have them on a standard Moomba tower? If so they will fit mine?
    $200 is price? ...
  20. Replies
    8
    Views
    1,155

    Option

    I've had the same issue with my 04 LSV. Instead of doing that work, I hunted around some boat shops and found a throwable life preserver (which is standard state requirement that you have one...
  21. Replies
    69
    Views
    6,986

    Thanks Volfo.

    Thanks Volfo.
  22. Replies
    69
    Views
    6,986

    Ok. Smrtz or Mid Tenn LSV, you guys need to...

    Ok. Smrtz or Mid Tenn LSV, you guys need to reply either that you want in on the Seadek deal or that your off. I went out to lake again last night and just get pissed every time I look back to see...
  23. Replies
    10
    Views
    1,051

    XLV3BGR. Let me know if you only wanted one. ...

    XLV3BGR.

    Let me know if you only wanted one. I am interested but only need one of the two. I'll be out in SLC in July and could arrange for payment/pickup. If you want both, no big. Just let...
  24. Replies
    11
    Views
    4,483

    those look to be a nice set. The speakers look...

    those look to be a nice set. The speakers look pretty good too. Is $500 the firm offer. May have a buddy that might be interested. Can you give specs on amp?
  25. Replies
    12
    Views
    960

    Update: Dug into this project last night. ...

    Update:

    Dug into this project last night. URRRRRG. Tried installing a little larger bolt (didn't work) so went to a larger diameter screw (didn't work). Not really anything to grab and keep a...
Results 1 to 25 of 41
Page 1 of 2 1 2