Search:

Type: Posts; User: David Analog

Page 1 of 7 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    2
    Views
    51

    Btw, if nothing else produces a change in status...

    Btw, if nothing else produces a change in status try temporarily disconnecting both remote controls from the HU and see if the HU suddenly becomes responsive.
    Look for a reset (per the manual) or...
  2. Replies
    2
    Views
    51

    Each brand of remote works on a different pulse...

    Each brand of remote works on a different pulse code and are not interchangeable. You can add a code-learning adapter and use another brand HU but you'll incur delays.
    In truth, Sony is no more or...
  3. Replies
    7
    Views
    161

    No doubt. The JL Audio M-series coaxials &...

    No doubt. The JL Audio M-series coaxials & components plus the MX650 coaxials are by heads and shoulders the most musically accurate speakers you can put in a boat.
  4. Replies
    7
    Views
    161

    Typically yes. But with four JL M series 770s in...

    Typically yes. But with four JL M series 770s in the cockpit, they need more power. A dedicated channel to each speaker is really the right call in this case.
  5. Replies
    7
    Views
    161

    If you have the MX series IB10 then 200 watts is...

    If you have the MX series IB10 then 200 watts is about right. But if you have the M series IB10 it could use more power. About 300 watts from an unregulated amplifier or 250 watts from a regulated...
  6. Replies
    15
    Views
    320

    DSP is no joke. I have it in my RV for radically...

    DSP is no joke. I have it in my RV for radically improved sound quality for those long drives. All future cars and trucks of mine will be DSP equipped.
    DSP may be used very differently in an open...
  7. Earmark Marine sells a variety of fans so you...

    Earmark Marine sells a variety of fans so you might get with Odin. He can also get you fixed up with a relay and the wiring instructions plus any instructions on a shroud.
    Again, the key to cooling...
  8. It is particularly tough on the top amp when two...

    It is particularly tough on the top amp when two amplifiers are mounted horizontally and the two amplifiers are very close to one another. An amp panel tilted back at a large angle will help minimize...
  9. If it's a Fusion speaker pod then the raw drivers...

    If it's a Fusion speaker pod then the raw drivers would be Diamond Audio and they are odd sizes. Difficult to replace and fit into the pod castings.
    The Fusion cast aluminum pods pit terribly. The...
  10. Replies
    10
    Views
    398

    With certainty you must have a marine amplifier...

    With certainty you must have a marine amplifier when you are in coastal or highly brackish areas. Salt and high mineral content is highly corrosive, especially for electrically charged circuits. ...
  11. Replies
    10
    Views
    398

    First, the tower speakers MUST have their own...

    First, the tower speakers MUST have their own dedicated channels. The demands placed on tower speakers (elevated in open air with the expectations of greater projection) are very different from the...
  12. Replies
    4
    Views
    148

    You can run dual voice coils in series, parallel...

    You can run dual voice coils in series, parallel or with separate amplifier channels. And you can run them in series or parallel with other identical woofers. There are many acceptable configurations...
  13. Correct. Same as Viva or Bounty.

    Correct. Same as Viva or Bounty.
  14. Yeah, I know of one but it's so old that it would...

    Yeah, I know of one but it's so old that it would have to be converted from the stone tablet.
  15. Retro. Yes. Like Class AB amplifiers and paper...

    Retro. Yes. Like Class AB amplifiers and paper subwoofers.
  16. Yes, since you would be dropping from a 4-ohm to...

    Yes, since you would be dropping from a 4-ohm to a 2-ohm load you would need to get away from a bridged four channel amplifier and go to a stereo 2-channel amplifier. Plus, the doubled up midbass...
  17. I agree with all the comments made above by Mike....

    I agree with all the comments made above by Mike. Back to the core issues. Mixing a 6.5" HLCD and a 10" HLCD is a waste of investment. A 10" has more than 3 X the surface area of a 6.5". So with the...
  18. The switch in question uses a 1-ohm resistor in...

    The switch in question uses a 1-ohm resistor in series with a 4-ohm tweeter. So the attenuation is too minimal to be of much value in changing the complexion of the speaker under active...
  19. A direct-radiating tweeter is not going to...

    A direct-radiating tweeter is not going to project well. It's by no means exclusive to the SXT65s. It's the nature of a surf speaker regardless of brand. A dome is designed to distribute over a wider...
  20. Replies
    5
    Views
    268

    The tough part of theft is that the tower...

    The tough part of theft is that the tower speakers or remaining collars are a clear advertisement that there is valuable gear in the boat....regardless of how it's designed and installed in the boat....
  21. Replies
    5
    Views
    268

    For anyone doing a bass-reflex 12-inch sub in the...

    For anyone doing a bass-reflex 12-inch sub in the future I might recommend the Wetsounds XS12 or the JL Audio 12W3.
    Both have the same size voice coil as the Exile and will handle the same amount of...
  22. Replies
    5
    Views
    268

    Bow-firing, hull-firing & down-firing, all have...

    Bow-firing, hull-firing & down-firing, all have one benefit in common. They use the surrounding planes and boundaries to enhance the low bass output. However, if the radiating surface area is reduced...
  23. Replies
    7
    Views
    421

    Here are a few close outs. ...

    Here are a few close outs.

    http://store.earmarkcaraudio.com/Xcart/home.php?cat=330

    The Access Tech 8" is a great speaker.
    Also check out the Kicker KMT6 and the Mako MBQ65.
    Although not...
  24. In this application, a woofer can create a...

    In this application, a woofer can create a surprising amount of internal pressure so a permanent airtight box is essential.
    It really needs to be a thermal bond which is the same as welding the...
  25. Replies
    7
    Views
    421

    I'm going to assume the impedance is a stable...

    I'm going to assume the impedance is a stable 4-ohm load without any excessive impedance dips. If the DC resistance measures 3.5 ohms or higher then you can likely run a small 4-channel amplifier in...
Results 1 to 25 of 174
Page 1 of 7 1 2 3 4