Search:

Theoretically the cooking line would tie into the raw water hose.

Yeah, sorry!

It looks like the bags have found a new home...

Sold.

I have had a few people express interest but they are not sold.

Here are a few photos. http://img.tapatalk.com/d/13/05/17/6e9ase5y.jpghttp://img.tapatalk.com/d/13/05/17/na5uhysy.jpg

The 1"fill...

I love enablers!

Yep, looking to add the 1180.

More ballast = more fun!

I'll pm you...

The moomba forum is my support group for my addictions.

Looks like a perfect fit!

I have a 650 from the playpen of my XLV and 2 standard size 400s.

Any interest?

$50 each for the 400s and $150 for the 650 + actual shipping.

There is always lead!!!

I am obsessed with more ballast.

I think that is the IBS and the factory tank.

Not sure but I think the tank is 500lbs and the IBS is 650lbs.

I installed the Tantrum Tow Ropes remote speed control this week. The install took about 10 minutes, 8 of which was me wiggling my fat body under the helm. It was a simple plug and play unit and...

If the strut is loosened it is likely to have move enough to warrant an alignment.

For sure! Bryan was riding a Hydroslide board that he picked up second hand. Nothing fancy about the gear just solid skill.

Is there a gasket? I recall a seal on both sides but don't recall anything between the housings.

I feel lucky and can't wait to try it out.

I had to pull the v-drive to remove the shaft assembly. It was much easier than fighting the shaft in place for me.

I was not able to separate the shaft and coupler in the boat.

I took out the entire shaft and took it to Elbert's (marine shaft shop). He got it loose in about a minute.

If you think your...

Still there...

http://shop.monstertower.com/p-141-pivoting-wakeboardsurfboard-rack-blackbrhurry-low-inventory.aspx

My little helpers.

At what point in the trailer wiring are you splicing in at?

Where is the first reading of the lower voltage?

I shimmed the mount with a random piece of rubber.1720217203

I use Rotella.

17197171961719817199

Ouch!

Elbert's repaired my shaft. I guess it is good to be local