Search:

Type: Posts; User: Bend

Search: Search took 0.00 seconds.

  1. Replies
    54
    Views
    4,819

    Well, well......not too proud to admit my...

    Well, well......not too proud to admit my mistakes. Got to lake Friday. Had rehearsed my plan of action to trace the wiring with the volt meter and wiring diagram as many of you had suggested...
  2. Replies
    54
    Views
    4,819

    It looks original to me. The engine paint...

    It looks original to me. The engine paint chipped off when a removed it.

    I've got the wiring diagram and I thought the same thing......I don't see a kill switch anywhere. I do see "warning...
  3. Replies
    54
    Views
    4,819

    17364 I replaced the Oil Sensing (sending??)...

    17364

    I replaced the Oil Sensing (sending??) unit. I didn't know what the oil pressure switch was until you told me. The wires at the switch had been spliced together to bypass the switch ever...
  4. Replies
    54
    Views
    4,819

    Not sure how to check the oil pressure switch. I...

    Not sure how to check the oil pressure switch. I did figure out that the wiring in the back of the engine was to bypass the oil pressure switch. Should I purchase a new one ($40)?? I should get...
  5. Replies
    6
    Views
    287

    98ROO, Sorry, reread your post and saw that you...

    98ROO,
    Sorry, reread your post and saw that you DO have power to your gauges. Not the same as I previously thought.
  6. Replies
    6
    Views
    287

    I'm having the same problem. Ignition tested...

    I'm having the same problem. Ignition tested good (12.3 volts to "start/run" position (red/red-yellow) and "on" (violet/red-yellow). But no reading on any other violet wire found anywhere on the...
  7. Replies
    54
    Views
    4,819

    [back from the lake-still no luck] Brought...

    [back from the lake-still no luck]

    Brought alternator home. Tested good.
  8. Replies
    54
    Views
    4,819

    Correction: Orange has 12.3 when ignition is in...

    Correction: Orange has 12.3 when ignition is in the START/RUN position.
  9. Replies
    54
    Views
    4,819

    There are three wires at the back of the engine:...

    There are three wires at the back of the engine: orange, red, and purple. Orange has 12.3 volts in the on position only. The purple and red don't show any voltage at anytime. I straight wired the...
  10. Replies
    54
    Views
    4,819

    Hold on. I lost my confidence. Back to the...

    Hold on. I lost my confidence.

    Back to the diagram. The ingition circuit breaker has two wires 1) Red and 2) Red/Violet. Since I ran the Red wire directly to the ignition switch....didn't just...
  11. Replies
    54
    Views
    4,819

    Folks, I may have just found sometnhing but I...

    Folks, I may have just found sometnhing but I won't know until I get back to the lake.

    I have reviewed my notes on my wiring of the new ignition and the wiring diagram. I have a red wire...
  12. Replies
    54
    Views
    4,819

    Check page three. The picture is near the bottom...

    Check page three. The picture is near the bottom on the page. I don't know why they were spliced but I [too] thought it must be something to do with the keyless igintion cause i know it didn't come...
  13. Replies
    54
    Views
    4,819

    Check page three. The picture is near the bottom...

    Check page three. The picture is near the bottom of the page. Thanks
  14. Replies
    54
    Views
    4,819

    parrothd, Finally got back to the lake. ...

    parrothd,

    Finally got back to the lake.

    replaced the oil sensing unit. Still no luck. Everything remains the same. I get fire from the engine in start mode but engine dies when in "on" mode...
  15. Replies
    54
    Views
    4,819

    This sounds promising. It didn't know what to...

    This sounds promising. It didn't know what to look for while I was at the lake this weekend. Makes sense.....I forgot to mention that I don't get the 12 volts to the fuel pump when the key is in...
  16. Replies
    54
    Views
    4,819

    Picture attached. Thanks 17029

    Picture attached. Thanks
    17029
  17. Replies
    54
    Views
    4,819

    17028 Hope this works.

    17028
    Hope this works.
  18. Replies
    54
    Views
    4,819

    I installed a standard key ignition and confirmed...

    I installed a standard key ignition and confirmed the wiring is correct. If I turn it all the way to start the engine fires and starts but i can't hold it in START long because I will ruin the...
  19. Replies
    54
    Views
    4,819

    Already installed a standard key ignition and...

    Already installed a standard key ignition and confirmed the wiring is correct.

    Thanks.
  20. Replies
    54
    Views
    4,819

    Bought from the person who purchased it at...

    Bought from the person who purchased it at Atlanta Marine. I'm on Oconee. My problem is my trailer needs work and I don't have a vehicle to pull it with anyway.
  21. Replies
    54
    Views
    4,819

    [Can't see where this was posted. Apologies if...

    [Can't see where this was posted. Apologies if re-posted]

    Thanks to all for the suggestions!

    Back from the lake. Problem remains. I don't have access to the internet at the lake so it...
  22. Replies
    54
    Views
    4,819

    Sensor, not gauge, correct? Located on engine? ...

    Sensor, not gauge, correct? Located on engine?

    Going up to lake this weekend. Will try this.

    Thanks.
  23. Replies
    54
    Views
    4,819

    I did not solve my problem last fall so I'm back...

    I did not solve my problem last fall so I'm back at it this weekend and hope to have some help from this forum. To add to my previous post I connected the fuel pump directly to the battery and it is...
  24. Replies
    54
    Views
    4,819

    OK, so that's the ECM? The 50 amp thing? Yes, I...

    OK, so that's the ECM? The 50 amp thing? Yes, I do have power to blower, radio, etc, so that is not my problem, right? i also put the volt meter to it and get 11.5 volts on it and the thing next...
  25. Replies
    54
    Views
    4,819

    I have the same problem as boat won't stay...

    I have the same problem as boat won't stay cranked. i have read this post and others so i will start in the middle. Please tell me if this is possible....



    The fuel pump does not cycle when...
Results 1 to 25 of 25