Search:

Type: Posts; User: cfdrews12

Page 1 of 2 1 2

Search: Search took 0.02 seconds.

  1. Replies
    282
    Views
    11,156

    Thanks all for the info, really helpful. Lots...

    Thanks all for the info, really helpful. Lots of knowledgeable folks on this thread. Diamond Lakes Water sports in Hot Springs AR shut down or sold out to a new dealership that is giving it a go....
  2. Replies
    282
    Views
    11,156

    So sorry for tagging on this thread as a Moomba...

    So sorry for tagging on this thread as a Moomba Outback owner, but my buddy just purchased a Craz and has all but 3.7 hours on it so far. We were out this weekend checking out all the bells and...
  3. Replies
    22
    Views
    1,626

    Anyone tell me where you change the settings for...

    Anyone tell me where you change the settings for the Percentage on Surf Plate? Also, my Craz is 4 mph off on the digital readout. Anyone know how to re-calibrate the digital speed reading?
    ...
  4. Replies
    39
    Views
    1,565

    Agree with Lee. I just put in this specific...

    Agree with Lee. I just put in this specific setup this year. Works very well. Instructions come with the setup so you know where the existing cables need connected and the new ones need...
  5. Replies
    6
    Views
    410

    Newty has two great checks that are easiest and...

    Newty has two great checks that are easiest and usually the cause of the issue. Pretty hard to hook up the battery cables incorrectly if your paying attention, however, I did have a similar issue...
  6. Replies
    10
    Views
    470

    I've got a 2004 Outback. when skiing hard,...

    I've got a 2004 Outback. when skiing hard, wakeboarding or surfing, we burn in the 7 gallons an hour range just to confirm your numbers. If the boat is not missing or running rough, then you may...
  7. Replies
    17
    Views
    1,112

    Ok, I'm going to throw everyone a curve ball...

    Ok,

    I'm going to throw everyone a curve ball based on recent research I've done. I've been on lots of Mastercraft, Supra, and Malibu forums lately because I've got to get some of my Vinyl...
  8. Replies
    14
    Views
    1,545

    i've tried multiple failed attempts, and are...

    i've tried multiple failed attempts, and are looking to do yet something different this year. While I still have my batteries and my amp installed on the port wall, tucked in and around the corner,...
  9. Replies
    14
    Views
    2,221

    One other option. Harbor Freight sells some...

    One other option. Harbor Freight sells some standard pullers (3 and 4 fork) in a package that works awesome. Around $25 bucks if I remember correctly in a 3 pack (small, med, large). Works...
  10. Replies
    8
    Views
    934

    Just replace the cable. I tried all the same...

    Just replace the cable. I tried all the same "defensive" things that you also have done but eventually the answer is to bite the bullet and replace the cable. I did this 1 season ago and the joy of...
  11. Replies
    2
    Views
    483

    If you've checked the fuse, also check and clean...

    If you've checked the fuse, also check and clean the connections on the back of the switch. They can get junked up over time and simply not having a good connection when you flip the switch means no...
  12. Replies
    8
    Views
    1,048

    Yes. You can also take it completely apart and...

    Yes. You can also take it completely apart and find out if you got a bind some where. When I installed a new steering cable last year, I grabbed the bar by hand where it connects. It actually was...
  13. Replies
    21
    Views
    2,298

    Also, need to check to see the pumps are working...

    Also, need to check to see the pumps are working correctly or engaging when you flip the switch. I found that in some cases my pumps were not working properly because of no electric connection from...
  14. Replies
    16
    Views
    2,443

    So Vandy, good riding with you this weekend. ...

    So Vandy, good riding with you this weekend. Reading your thread reminded me that you don't have your throttle cable zip tied. When we were looking at your engine and doing the head scratching, I...
  15. Replies
    4
    Views
    1,457

    Just to confirm from my last year experience: ...

    Just to confirm from my last year experience:

    1) Pull the floor. The cables are zip tied and you can do some damage to other tubing and items that also run under the floor by pulling via a rope...
  16. Replies
    8
    Views
    1,715

    Flush Kit

    Does this cause the impeller to burn out? This looks like it by passes the impeller. I can't tell from the picture, maybe you installed it just after the strainer up from the raw water intake and...
  17. Replies
    15
    Views
    1,022

    Vinyl Rip

    I've used a product you can get at Overtons or Amazon.com called Tear-Aid. Small holes or tears can be covered with this and get you through the season until you want to get them repaired or fixed....
  18. Replies
    5
    Views
    742

    LSV Steering Cable

    Did you find the part number for the LSV Steering Cable Replacement? I've unhooked mine from Rudder (pain to reach but easy) and have loosened the 4 bolts that hold the cable shaft tight in back
    ...
  19. Replies
    14
    Views
    8,259

    Solved

    OK. Just information back to the group in case you run into this and didn't think to try it out.

    #1. I've learned to take out my starter and put it back in in under an hour. Remarkable but...
  20. Replies
    10
    Views
    1,036

    Boat Starting Issues

    So I'm jumping over to this thread because I'm experiencing same type of issues and can't figure it out. Thanks gcnetti for taking the time to be part of thread. So here is what I've done to try...
  21. Replies
    14
    Views
    8,259

    Starting

    So I appreciate all the help. So far this is what I've done. I've checked the resistance on the power cable that goes between battery and Starter. 1.3, so I assume this means cable is still good. ...
  22. Replies
    14
    Views
    8,259

    Sounds same as my no-start trouble.

    So I'm on the lake and can't get the boat to start. Same clicking that everyone in this thread talked about. But only clicking, time and time again. So hooked up another battery and jumped the...
  23. Replies
    21
    Views
    2,031

    Speakers

    Noticed the re-post. Give me the details:

    Looks like they are in good shape. Any issues with them?
    Did you have them on a standard Moomba tower? If so they will fit mine?
    $200 is price? ...
  24. Replies
    8
    Views
    1,283

    Option

    I've had the same issue with my 04 LSV. Instead of doing that work, I hunted around some boat shops and found a throwable life preserver (which is standard state requirement that you have one...
  25. Replies
    69
    Views
    7,258

    Thanks Volfo.

    Thanks Volfo.
Results 1 to 25 of 45
Page 1 of 2 1 2