Search:

Type: Posts; User: Poison

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    123

    The 50A fuse to the IX and the 80A fuse for the...

    The 50A fuse to the IX and the 80A fuse for the 700.5 are in the fused distro block and not in addition to it right?

    So for a dude who has slept several thousand times since my 1 EE circuits class...
  2. Replies
    3
    Views
    123

    Distribution Blocks and Fusing

    Iím replacing an amp in my boat pretty soon and I have some questions on fuses and wiring. What I have now is working fine, but I figured I would pull it all out anyway in the name of aesthetics...
  3. Trayson, do you also have an 1100 in the...

    Trayson, do you also have an 1100 in the non-surf side? (Trying to figure out how much half full is). I have a the 07 XLV which is basically the same hull so I'm going to try your setup. Also,...
  4. Replies
    19
    Views
    386

    Right on. The fuse panel that was my culprit...

    Right on. The fuse panel that was my culprit says solenoid, so I just stuck with that. I routinely screw up the nomenclature with some of these parts. Did you upgrade the ballast to the three fill...
  5. Replies
    19
    Views
    386

    No, it controls the solenoids on the manifold...

    No, it controls the solenoids on the manifold that go to the individual bags. The manifold sits on top of the transmission on my boat. At least I assume that is the solenoids that the fuse is for. ...
  6. Replies
    18
    Views
    363

    When I was having starting problems, I found one...

    When I was having starting problems, I found one of the wires to the starter was loose. The nut had backed off a bit and the wire was just hanging loose on the starter. I tightened it down and the...
  7. Replies
    19
    Views
    386

    They all share the same pump, but there is a fuse...

    They all share the same pump, but there is a fuse for each one (3 amp I think). The fuse is actually for the solenoid that selects which bag the pump is filling. It is located under the drivers...
  8. Replies
    1
    Views
    120

    I replaced the stock one with a Kenwood...

    I replaced the stock one with a Kenwood KCA-RC60MR a couple years ago. It is roughly the same size and installed quick and easy. It is kind of a funky color though. Replacing the remote is fairly...
  9. Replies
    65
    Views
    4,233

    If that is indeed your problem, it can usually be...

    If that is indeed your problem, it can usually be fixed by using gas that is ethanol free.

    Happens on my boat when we run it really hard with a lot of ballast and then stop for an hour in the...
  10. Replies
    65
    Views
    4,233

    VegasJay, that sounds like a textbook vapor lock....

    VegasJay, that sounds like a textbook vapor lock. Pour some water on the fuel pump next time it does that and it should start right up.
  11. Replies
    8
    Views
    361

    Let us know what you figure out and how you get...

    Let us know what you figure out and how you get it going/replaced. I've had the same problem with mine for a year or so. Just reads --.
  12. Replies
    9
    Views
    1,855

    I'm having the same issue. I also have the...

    I'm having the same issue. I also have the KCA-RC60MR that I used to replace the stock remote. It runs fine on the trailer, and for about the first hour or two on the water, then it just seems to...
  13. Replies
    14
    Views
    984

    Left the plug out last year. Self-critiquing. ...

    Left the plug out last year. Self-critiquing.

    Drove away from the ramp at the end of the day with a wakeboard on the transom. Again...self-critiquing.
  14. Replies
    10
    Views
    2,019

    http://pages.suddenlink.net/kasquires22/images/08....

    http://pages.suddenlink.net/kasquires22/images/08.JPG

    Next came the KM6500.2 install. For the record, this thing is awesome. It came at the recommendation of David at Earmark and I must say I am...
  15. Replies
    10
    Views
    2,019

    Afterwards I ran the RCA cables for the EQ. I...

    Afterwards I ran the RCA cables for the EQ. I just ran them through the bilge where the front ballast bag sits and then up through the floor similar to the way DOCDRS did his in an older post. I...
  16. Replies
    10
    Views
    2,019

    My Spring Project

    I decided to make a thread to show off my new setup for the summer. More than that though, I wanted to gather this info to help anyone else who winds up in my situation. Three months ago, I was...
  17. Replies
    13
    Views
    2,156

    Thanks Phil. BTW, check your private messages. ...

    Thanks Phil. BTW, check your private messages. I sent a question. I purchased my 6500.2 from Earmark, but my buddy was asking about another dealer and raised some questions.
  18. Replies
    13
    Views
    2,156

    Anybody have pictures?

    Anybody have pictures?
  19. Replies
    13
    Views
    2,156

    Bringing up an old thread here. My new 6500.2...

    Bringing up an old thread here. My new 6500.2 set recommends filling 50%-100% of the can with poly-fil. I've been reading up and I understand to loosely fill it up. Just so I'm clear, its ok if...
  20. Replies
    12
    Views
    1,773

    Should have seen that one coming:p Believe it...

    Should have seen that one coming:p

    Believe it or not, that nickname has nothing to do with Bret Michaels.
  21. Replies
    12
    Views
    1,773

    Any other recommendations...something good? If I...

    Any other recommendations...something good? If I blast Nickelback, the neighborhood will laugh me out of the cul-de-sac:D
  22. Thread: Upgrade Options

    by Poison
    Replies
    40
    Views
    3,565

    Good to know. Do you typically splice the...

    Good to know.

    Do you typically splice the source pcont three ways, or daisy chain them?
  23. Thread: Upgrade Options

    by Poison
    Replies
    40
    Views
    3,565

    The WS420 instructions say a relay may be...

    The WS420 instructions say a relay may be necessary. Right now my one amp just has a direct line to the remote power (blue) wire from the head unit. Since I'm planning on adding another amp and the...
  24. Thread: Upgrade Options

    by Poison
    Replies
    40
    Views
    3,565

    The sub is actually a 10" Kenwood. The manual I...

    The sub is actually a 10" Kenwood. The manual I have is for both a KFC-XW1002DVC or KFC-WPS1002D...so its one of those two and both have same specs. It has two inputs that can be used in either...
  25. Thread: Upgrade Options

    by Poison
    Replies
    40
    Views
    3,565

    I've been working on some upgrades myself and...

    I've been working on some upgrades myself and emailing David a bit for prices. Also giving myself a crash course in audio equip. Here is what I'm looking at and a couple of questions. Maybe you...
Results 1 to 25 of 32
Page 1 of 2 1 2