Search:

Type: Posts; User: DOCDRS

Page 1 of 20 1 2 3 4

Search: Search took 0.12 seconds.

  1. it was the exhaust as well in 2007, i believe it...

    it was the exhaust as well in 2007, i believe it was a tuned exhaust and maybe cat as well, the 325 was standard old time
  2. Replies
    8
    Views
    877

    Sticky: There is a sticky in the how to section on...

    There is a sticky in the how to section on this.......it's very simple once you've done it

    http://www.moomba.com/msgboard/showthread.php?10834-Prop-Shaft-Alignment-Yearly-Maintenance-Item
  3. Replies
    8
    Views
    156

    We found when kayak surfing that it much easier...

    We found when kayak surfing that it much easier to get back into the kayak off the platform located at the back of the boat. You do have to wait for the boat to come back around and stop rather than...
  4. Replies
    8
    Views
    156

    I think he must have gotten hit by one of those...

    I think he must have gotten hit by one of those fast approaching balls !!!!!!
  5. Replies
    23
    Views
    801

    Im confused here....what balls?.....how does one...

    Im confused here....what balls?.....how does one of these balls come at you?.....or even how do you come at one of these balls when your are surfing mainly behind the boat......are you running the...
  6. Replies
    8
    Views
    377

    I have never removed the vdrive plugs. removing...

    I have never removed the vdrive plugs. removing the outlet and strainer hose and will allow the majority of the water drain. then you can use a shop vac to finish the job. After everything has been...
  7. Replies
    4
    Views
    309

    What mla said

    What mla said
  8. Replies
    13
    Views
    839

    The intake vdrive impeller block exhaust...

    The intake vdrive impeller block exhaust manifolds and muffler hold approx 20litres or 5 us gallons ( I measured it). I would say the the block holds about 12 litres or 3 us gallons.
  9. Replies
    13
    Views
    839

    Be very careful doing this, the thermostat is...

    Be very careful doing this, the thermostat is only starts to open at 160. Then when you introduce the cooler antifreeze the thermostat will close stoping any more water from leaving the block. The...
  10. Replies
    5
    Views
    261

    Boone is right loan drive pressure sensor. Your...

    Boone is right loan drive pressure sensor. Your light should be on at idle and then go out around 8-900 rpm. If it stays on then its a sign of low oil in your vdrive
  11. Replies
    3
    Views
    129

    You just have to take the two bolts out that hold...

    You just have to take the two bolts out that hold the impeller pump bracket to the block.
  12. Replies
    1
    Views
    100

    Canadians...Canadian tire deal stabil

    i went into my local CT dealer to buy some stabil that was on sale....the ct brand ended up at about 5.50 on a store sale deal for a litre to treat 300 litres or 66 imp gal or 75 us gal.......fyi
  13. Replies
    5
    Views
    326

    I just replaced my 09 belt, took about 20 mins, I...

    I just replaced my 09 belt, took about 20 mins, I used good year gator back. Search my name ,it was a 26$ belt
  14. Replies
    10
    Views
    354

    42 is nice for one foot toe holds

    42 is nice for one foot toe holds
  15. Replies
    91
    Views
    14,777

    Sticky: With the nuts loose you should be able to move...

    With the nuts loose you should be able to move the prop shaft and coupler front to back the amount that you loosen the nuts. Sometimes the two couplers can be stuck and a slight bump of the engine...
  16. Replies
    91
    Views
    14,777

    Sticky: 1. Loosen the 4 9/16 bolts a few turns so you...

    1. Loosen the 4 9/16 bolts a few turns so you can free the driveshaft output flange from the prop shaft flange.......if the two flanges are stuck together just bump the engine over

    2. Now pull...
  17. Replies
    4
    Views
    237

    I knew there would be an easy...

    I knew there would be an easy solution.........thanks Pat.
  18. Replies
    4
    Views
    237

    2009 depth finder not working

    My depth finder only reads 997. Air n lake temps are good. Harness connectors seem fine. Any ideas on this before I deg deeper?
  19. Replies
    4
    Views
    228

    I take a washer that will fit between the bracket...

    I take a washer that will fit between the bracket and holder at the top , then bend the washer with 2 vice grips so you can remove it in the fall. I others have used lock washers so they don't fall...
  20. Replies
    0
    Views
    115

    Alternator belt change

    Indmar 4060425. alternator belt change


    Tools


    9/16. Wrench and socket
    6mm. Allen key , or Allen socket. NOT 7/32. You may strip the bolt
    Extender for Allen key to get enough force to...
  21. Replies
    1
    Views
    211

    You need a mefi v scanner , odb II will not work

    You need a mefi v scanner , odb II will not work
  22. Thanks KG.

    Thanks KG.
  23. Found Baby fly in Spiders Web....what do I do

    Omg , came home tonight and found a spiders web between my boat trailer guide pole and my boat. I went to swipe it off when I noticed a baby fly that lost its poor way and is trapped in the web. I'm...
  24. Thread: Impellers

    by DOCDRS
    Replies
    24
    Views
    1,124

    Yes , all boats come with a spare impeller. It is...

    Yes , all boats come with a spare impeller. It is located on the underside of your clamshell for dd's and taped to the rear port side hidden by the muffler on vdrives. Saved my bacon more than once.
  25. Thread: Like cheese?

    by DOCDRS
    Replies
    10
    Views
    525

    I thought thats where most of the cheese heads...

    I thought thats where most of the cheese heads were from.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4