Search:

Type: Posts; User: MLA

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. Thread: rewire

    by MLA
    Replies
    9
    Views
    226

    Strangle enough, we've had some RGB noise coming...

    Strangle enough, we've had some RGB noise coming in on the speaker wires as they run parallel through the tower. Isolating the controller to a different battery made no difference. If you are using a...
  2. Thread: rewire

    by MLA
    Replies
    9
    Views
    226

    I dont want to see it happen again either. What...

    I dont want to see it happen again either. What you described seems to be common on golf carts. Check out some of those forums and you will see the results of loose cables or cables stacked in the...
  3. Thread: rewire

    by MLA
    Replies
    9
    Views
    226

    This sounds like there may have been too many...

    This sounds like there may have been too many terminals on that post, or they were incorrectly stacked, or loose. A traditional 1/2/BOTH/OFF switch is not the ideal switch for use with an ACR. I...
  4. Replies
    16
    Views
    387

    Not the boat, but a few heads here im sure :p

    Not the boat, but a few heads here im sure :p
  5. Replies
    16
    Views
    387

    Yes, the Syn-2 is a good amp for 2 pair of 8"...

    Yes, the Syn-2 is a good amp for 2 pair of 8" HLCD. Another option that would drive them to their full potential would be the Wet Sounds SD-2, which would net over 300W rms to each or the Arc Audio...
  6. Replies
    16
    Views
    387

    The WS-420 is an awesome marine EQ because its 2...

    The WS-420 is an awesome marine EQ because its 2 EQ's in one chassis. You can adjust the typically larger tower speakers totally independent from the smaller in-boats.

    If you do add a 2nd, I...
  7. Replies
    16
    Views
    387

    I agree that your current rockford amp in 2 chnl...

    I agree that your current rockford amp in 2 chnl bridge mode @ 300W rms is a good spot for most any 8" HLCD. Subtract a little wattage from its rated 14.4 voltage to a more realistic 13.5 and you...
  8. Replies
    63
    Views
    1,577

    Are these the custom surf sacs from Moomba/Supra...

    Are these the custom surf sacs from Moomba/Supra or the Fly High W719 Jumbo Surf? From what I hear, as well as measurements, the W719 is not a good fit. Good value though, cant beat the net weight...
  9. Replies
    4
    Views
    117

    To my knowladge, the only two current Sony models...

    To my knowladge, the only two current Sony models that will actually support the LCD remote, are the DSXS310BTX and DSXMS60. This is the time of year when new stuff rolls out and old stuff goes away,...
  10. Replies
    3
    Views
    89

    This is really two different questions with 2...

    This is really two different questions with 2 different answers. There are only 3-4 actual wet cell lead acid battery manufactures producing 90% of the brands you see here in the US. Most are good...
  11. Replies
    8
    Views
    186

    Out of their plastic enclosures, the zone...

    Out of their plastic enclosures, the zone controllers are roughly 1 x 2 x 5/8 thick.

    http://i181.photobucket.com/albums/x101/chpthril/chpthril113/P2120014_zps8cc133b8.jpg
  12. Replies
    3
    Views
    89

    Cant speak at all to the quality or reliability...

    Cant speak at all to the quality or reliability of that battery. But, a group-27 with 90 Ah is about average for that class. That will be fine for a 2nd battery bank, but may not be enough reserve if...
  13. Replies
    12
    Views
    207

    Tinning the stripped end is ok as ling as the...

    Tinning the stripped end is ok as ling as the bare wire doesnt shroom out when the insulation is stripped off. Sounds like it prevented the set screw from seating deep enough for the blocks cover to...
  14. Replies
    12
    Views
    207

    OFC is better quality. No, but depends on who...

    OFC is better quality.

    No, but depends on who things are wired. For the tower speaker and amp setup, you are going to need a 2 conductor for each pod. 14ga will do. For the in-boats on the 400.2...
  15. Replies
    31
    Views
    629

    You can answer that question yourself. Look up...

    You can answer that question yourself. Look up the model 12V you currently have and see what the Ah rating is and 2 x it. Now, look up the 6V you wont, and see what its (use the spec from only one)...
  16. Replies
    12
    Views
    207

    Just watch, because knukonceptz "good deal" stuff...

    Just watch, because knukonceptz "good deal" stuff is usually CCA wire.

    If space is an issue, use four single conductor 12ga primary wire over two 2-con speaker wire. Speaker wire often times has a...
  17. Replies
    31
    Views
    629

    Just to add to viking's info. You have to use two...

    Just to add to viking's info. You have to use two 6V in order to have a usable 12 volt bank. If you want a larger bank, you then have to add another pair of 6V, in order to maintain a usable 12 volt....
  18. Replies
    10
    Views
    245

    Targeting above a speaker's RMS is never a bad...

    Targeting above a speaker's RMS is never a bad thing. The added headroom means performance can be achieved at a lower volume dial setting and the gain level can be set lower. Also, keep in mind that...
  19. Replies
    31
    Views
    629

    Based on that info, I would not hesitate to go...

    Based on that info, I would not hesitate to go with another group-27 wet-cell, and Id probably make a dual-purpose.
  20. Replies
    10
    Views
    245

    A single amp option for the rev-8 would be the...

    A single amp option for the rev-8 would be the HT-4. 300W rms potential.
  21. Replies
    31
    Views
    629

    Being a dedicated house battery, if its getting...

    Being a dedicated house battery, if its getting depleted while at anchor, how is it getting recharged?
  22. Replies
    22
    Views
    723

    Ive done it on a number of our Kicker Promo...

    Ive done it on a number of our Kicker Promo boats, like the one you saw, because I know how the system will be used. Its a lot to ask of any typical amp, but I have confidence in the Kicker product....
  23. Replies
    10
    Views
    245

    I would suggest that you consider not using a...

    I would suggest that you consider not using a single amp for those 2 zones, unless its something like the Wet Sounds SD-4 or Syn-6. These amps will handle the load without batting an eye. Those are...
  24. Replies
    19
    Views
    412

    brn/wht wire looks to be bilge.

    brn/wht wire looks to be bilge.
  25. Replies
    22
    Views
    723

    Yes, the KXM400.2 would deliver 100W rms x 2 @ 4...

    Yes, the KXM400.2 would deliver 100W rms x 2 @ 4 ohm, so 100W to each speaker with one pair. 200W rms x 2 @ 2 ohm when a pair is wired in parallel to each chnl. They split the 200 and net 100W.
    ...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4