Search:

Update. So I checked the alignment which looked good and decided to put the boat on trailor to change prop/shaft etc.. As I'm idling out of cove I don't feel any vibration so as I leave the cove I...

I put the boat in gear while on the boat lift. I ran it for about 30 seconds in gear and no vibration. Does this mean that it's the prop? I looked at the vdrive while in gear at the point where you...

No the shaft didn't snap but i could only go about 5 mph back to the dock, anything above that causes a bad vibration and didn't want to take any chances.

not sure why it bogged down. Felt almost like hitting a sand bar but I was in 30 ft of water and I know there was no sand bar in that area of the lake. I don't remember any large thumps like I would...

3rd time out this season and was driving when all of a sudden the boat bogged down and started vibrating. I took it back to my boat lift to check the prop. There are a few nicks but nothing too...

What would the height and width be?

Came across a good deal on a custom box for the sub I have. Problem is that my boat is at the shop and need to make sure it will fit under the drivers area. I have an 07 xlv and need to know the...

This winter I plan on upgrading my sub enclosure. Is exile still making these for the moombas? Those that have them are you still happy with them? Thanks in advance.

I'm interested. Can someone PM me with price info on both models. Thanks

I was told, but haven't tried yet, to add fabric softener to a steam cleaner and go over the carpet with it after you get it nice and clean. Supposed to bring it back to life

+1 on crutchfield being over priced. Also check out woofersect.com

I have been told that one downside is that if you are on lake and isolator goes bad you will not realize until its too late and both batts run dead.

Thinking about getting the sub box from Brian but I have an xlv. I emailed him some measurements to see if it would fit. He hasn't had a chance to reply to my email so I figured I ask if you...

I tried using my 12v outlet for the first time to charge my iphone in my boat and neither one would seemed to be getting any power to them. I have one located by the driver and one by the radio. ...

My plan was to pickup one 1000 watt sub now and have the option to add another one later if the amp would push 1000 watts to each. That's why I was thinking of getting 4 ohm dvc subs. But since they...

I plan on getting a new mono amp that is one ohm stable. At 1st I plan on getting a single 12" 4 ohm DVC and running it parallel to make it a 2 ohm load. Later on I plan to add an additional 12" 4...

Here are a few more pics. And the last one is for the guys up north that doesn't belive that it snows in Texas, in FREAKING March

Here are some pics of the motor and switch. I know the switch is wired correct because it came off a working lift. So the question is related to wiring it to motor

I am putting in a new lift and was given a used Magnetek 3/4 hp motor and switch to use to raise boat up and down. I have searched for a wiring diagram and can't seem to find one. The motor has 6...

nevermind got it to play.

Which Codec did you download? Downloaded bunch different ones and still cant get it to play.

Brian I sent PM. very interested

My boat was broken into and my stereo system was stolen. When taking the amps they disconnected the two batteries and Perko switch. Now I'm trying to hook the batteries back up and am a little...

I’m finally getting around to building a new boat lift and decided not to have the pipes hot dipped galvanized for cost reasons. I need to paint the pipes and was wondering if I should use a special...

Thanks for the reply. Did your contractor build your cradle or did he buy from a manufacturer? Any idea on the cost of the cradle and motor? Thanks again.