Search:

Type: Posts; User: mobius maximus

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    147

    Awesome, thanks!

    Awesome, thanks!
  2. Replies
    2
    Views
    147

    prop shaft alignment

    I remember seeing a thread that had the procedures for aligning the prop shaft basically step by step, but can not seem to find it again. If anyone can point me out in the right direction it would be...
  3. Replies
    1
    Views
    186

    Wake surf racks

    Any one know of any decently priced surf racks for a rad-a-cage tower. Not looking for any swivel racks. It's on a 02 Mobius lsv. Thanks.
  4. Replies
    18
    Views
    660

    I checked the polarity with a volt meter. And the...

    I checked the polarity with a volt meter. And the speaker would have no response to it. Neither sucking in or out.
  5. Replies
    18
    Views
    660

    Wet Sound speaker rebuild

    I've been looking through the previous posts and couldn't find anything on this. I have the wet sound rev 8 tower speakers and unfortunately one of the speakers is dead.The speaker is not blown...
  6. Replies
    1
    Views
    121

    oil pressure indication issue

    After the engine starts the oil pressure is spot on at 40psi. Pressure corresponds to throttle as it is moved. But eventually the pressure drops of to about 5-10psi and the gauge will occasionally...
  7. Replies
    7
    Views
    312

    ive been searching for a service manual but can...

    ive been searching for a service manual but can only find the operator manual which is of no help. any idea of where i can find one? preferably online. thanks
  8. Replies
    7
    Views
    312

    parrothd- we have not tried to swap the plugs any...

    parrothd- we have not tried to swap the plugs any higher than idle, but it does kill it when we swap the plugs at idle. we tried starting it with the shunt installed but it wont start. it'll crank...
  9. Replies
    7
    Views
    312

    Engine Timing

    Hey guys, just installed a new engine in my 02 mobius lsv and need to do the timing on it. I have the distributor jumper plug but every time we try to swap the harness plug for the jumper plug to...
  10. Replies
    3
    Views
    374

    i just bought the Sharkskin Plus from Westland...

    i just bought the Sharkskin Plus from Westland covers. Hope its a pretty good fit. I'll put up some pics once i get it installed.
  11. Replies
    3
    Views
    374

    Boat Cover for 02 Mobius LSV

    I have a 2002 mobius lsv. Looking for a new cover and it seems that iboats.com doesn't have an exact fit cover for the 2002 model. But they have the exact fit for the 2003. I checked the dimensions...
  12. Replies
    0
    Views
    299

    Mallory HEI distributor?

    Curious if anyone knows if a Mallory HEI distro is compatible on marine engines? Thanks!
  13. Replies
    5
    Views
    609

    No the connections were deffinately tight. That...

    No the connections were deffinately tight. That was the first thing we had checked.

    What kind of battery do you guys recommend. I was looking at optima marine batteries. Pretty expensive. As is...
  14. Replies
    5
    Views
    609

    Battery???

    I took my boat out last weekend and before we went out the battery was dead. Threw some jumper cables on it and charged it with my truck for a bit. Then took her on the water. Then about 5 hours into...
  15. Replies
    10
    Views
    728

    Yea i did the check this morning and the lowest i...

    Yea i did the check this morning and the lowest i got was 120 and the highest i got was about 150. Im thinking itll be alright. And according to the indmar manual its saying the minimun psi is 100...
  16. Replies
    10
    Views
    728

    Alright awesome. So basically as long as the...

    Alright awesome. So basically as long as the average pressure is above 125 and they are all within 10% of each other i should be good?
  17. Replies
    10
    Views
    728

    Awesome thanks guys. I was just searching the...

    Awesome thanks guys. I was just searching the interwebs and i found a indmar manual and its saying nothing less than 100psi. And as you said kane, they should be within 10%.

    Thanks very much...
  18. Replies
    10
    Views
    728

    Compression check?

    Does anyone happen to know the correct pressure range for checking compression on a 350 indmar assault? Had my muffler blow up on me and wanted to make sure i didnt blow out any piston rings. Thanks...
  19. Replies
    8
    Views
    1,146

    I just took my 2002 mobius lsv out this weekend...

    I just took my 2002 mobius lsv out this weekend for the first time this year. Within 5-6 min on the water....KABOOM!!! My muffler had literally exploded. I had just opened up the throttle and within...
  20. Replies
    17
    Views
    1,862

    Yea that looks pretty awesome. Im deff going to...

    Yea that looks pretty awesome. Im deff going to have to take a look into that one man. That thing looks pretty awesome
  21. Replies
    17
    Views
    1,862

    Thanks alot for the input guys. Beat Taco-...

    Thanks alot for the input guys.

    Beat Taco- what exactly is that?
  22. Replies
    17
    Views
    1,862

    Yearly service?

    Ive been searching through all the threads and cant seem to find any about typical yearly servicing. This is the first time I'm having to de-winterize my boat since I bought it. Just trying to find...
  23. Replies
    4
    Views
    807

    Transom lights

    Has anyone ever installed underwater transom lights before? Ive been browsing through the forums and couldnt find any posts on it. If anyone has some pics of it would be appreciated. Thanks guys!
  24. Replies
    1
    Views
    198

    windshield frame!

    Out on the water this weekend and hit a random swell pretty hard with the boat an it somehow happened to break my driver side windshield frame bottom piece. Anyone know where i can maybe get a new...
  25. Replies
    1
    Views
    215

    random rpm surge........

    While sitting at idle ive noticed the engine randomly surges a couple hundred rpm's. Anyone think of any causes/ reasons this may be happening? Thanks
Results 1 to 25 of 27
Page 1 of 2 1 2