Search:

Type: Posts; User: REDFIVE48

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    191

    Saw those on the Mojo video and was thinking I...

    Saw those on the Mojo video and was thinking I would like some myself. I recently bought a SeaDek pad that I cut in a couple pieces and put one on port and one on starboard side gunwales, but...
  2. Thread: Pela 6000?

    by REDFIVE48
    Replies
    4
    Views
    161

    If you use the bottom drain, don't forget to open...

    If you use the bottom drain, don't forget to open the fill cap or pull the dipstick out so it will actually let the oil out the bottom. It's pretty easy, I've done thru the dipstick before. When...
  3. Plus 10 for the ear protection, I popped an ear...

    Plus 10 for the ear protection, I popped an ear drum on a fall a few years back, the medical co-pays were more than a damn helmet. Now I don't ride or let me kids ride without one, plus, it's where...
  4. Replies
    14
    Views
    349

    I've seen the Simple Green recommendation, but...

    I've seen the Simple Green recommendation, but seen others recommend throwing a couple bags of ice in the bilge with the cleaner so the ice will aggitate while you are cruising around. Also seen...
  5. Replies
    8
    Views
    240

    Re: A little video from this past weekend

    Awesome, thanks for the tip

    Sent from my Slider SL101 using Tapatalk HD
  6. Replies
    8
    Views
    240

    Well done! I need one of those arms for my GoPro.

    Well done! I need one of those arms for my GoPro.
  7. Replies
    14
    Views
    317

    Funny, glad the hotwire instructions have been...

    Funny, glad the hotwire instructions have been able to help so many. I documented the wiring while putting in a push button start (not as cool as my buddy's push button start and stop, but still...
  8. Replies
    3
    Views
    119

    If you look between the Vdrive and the motor,...

    If you look between the Vdrive and the motor, that is the transmission, you should see a dipstick on the left side if looking from inside the boat. I normally change my transmission fluid at the...
  9. Replies
    3
    Views
    92

    This used to happen to me a lot in the last few...

    This used to happen to me a lot in the last few years, but haven't seen it happen yet this year. What has changed this year:
    I don't use my boat as much (hurt my back :( )
    I now have dual...
  10. Replies
    30
    Views
    1,059

    wonder if the key is bent and sandwiched between...

    wonder if the key is bent and sandwiched between the prop and the shaft outside it's slot. Thought someone else had a key problem also. Good luck, hope they get it soon.
  11. Replies
    30
    Views
    1,059

    They can fix it, they fixed mine with tears in...

    They can fix it, they fixed mine with tears in the metal, came back looking like new
  12. Replies
    404
    Views
    31,676

    At that price, think I'd rather have the SeaDek...

    At that price, think I'd rather have the SeaDek Nautique
    http://www.seadek.com/blog/seadeks-super-air-nautique-230-for-sale-2/
  13. Replies
    30
    Views
    1,059

    Kit is pretty pricey, think I got a prop puller...

    Kit is pretty pricey, think I got a prop puller from Nettles for 60 or 80 USD. Think I can come up with a bag, wrench, pliers, and cotter pin for less than $100.
  14. Replies
    30
    Views
    1,059

    read someone else used heat on their prop to...

    read someone else used heat on their prop to release, but I always put the prop puller on then use a hammer hitting from the rudder toward the prop. Usually pops off with a few hits on the prop...
  15. Replies
    25
    Views
    880

    Yes, lake tested yesterday, wasn't dripping that...

    Yes, lake tested yesterday, wasn't dripping that I could see while under power, shut it down and floated for a bit and saw it dripping about 1 every 5 sec, so I broke out the wrench and tightened it...
  16. Replies
    25
    Views
    880

    Yes, mine drips from the packing nut, but after...

    Yes, mine drips from the packing nut, but after spending multiple hours on Saturday repacking with goretex pack, am hoping not to see any drips when I get back on the lake today for a test (finished...
  17. Replies
    25
    Views
    880

    Page 50 of the manual (use this one if you don't...

    Page 50 of the manual (use this one if you don't have a paper copy: http://moomba.com/downloads/owner_manuals/moomba_03.pdf)

    Shaft Log Packing Nut section.

    I don't have your year and model so...
  18. Replies
    25
    Views
    880

    Sounds like pack bushing to me as mine is just as...

    Sounds like pack bushing to me as mine is just as bad. To see for yourself look for your prop shaft in the engine compartment. If you are on the water, you will probably see it dripping water...
  19. Replies
    22
    Views
    740

    This describes my system with my wife, except she...

    This describes my system with my wife, except she drives the truck. I hate the other boaters that can't engage anyone one of the other 8 people with them to either drive the boat or the truck and...
  20. Thread: Prop Grease

    by REDFIVE48
    Replies
    6
    Views
    265

    Believe you are supposed to grease the prop when...

    Believe you are supposed to grease the prop when reinstalling, I have done everytime I changed props. I think I just use the same grease I have for my garage door opener, white lithium grease in the...
  21. Replies
    4
    Views
    149

    Going to assume your pack bushing is not dripping...

    Going to assume your pack bushing is not dripping a lot? I need to repack mine because my bilge runs about that often, regardless of rain soaking.
  22. You don't need to have a new switch to test if...

    You don't need to have a new switch to test if the old one is bad, just jump the wires (hotwire) by removing all 3 from the switch, then you should be able to figure out by process of elimination...
  23. Replies
    65
    Views
    2,767

    That little red button left me stranded on the...

    That little red button left me stranded on the lake one day. Shorted out my electrical system with an air inflation pump plugged into my 12V outlet, but the pump had a crossed wire. Had no idea...
  24. Replies
    65
    Views
    2,767

    left the wires hooked to the sensor, good luck!

    left the wires hooked to the sensor, good luck!
  25. Replies
    65
    Views
    2,767

    looking at you motor from the passenger cabin, it...

    looking at you motor from the passenger cabin, it is on the intake manifold directly in front of you and before the spark arrestor. It has a plug with wire loom plugged into it and is held in by 2...
Results 1 to 25 of 75
Page 1 of 3 1 2 3