Search:

Type: Posts; User: louisiana21v

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    1,369

    I have been running an old Q-logic prefab ported...

    I have been running an old Q-logic prefab ported box for years with an even older hand me down JL 12. It was reliable and loud but was starting to fall apart. I put a new Alpine Type R in the box...
  2. Replies
    3
    Views
    697

    Alpine makes something almost exactly like this. ...

    Alpine makes something almost exactly like this. I have one in my Avalanche on 4 6.5" seperates. It was cheep, small and easy to install. It just taps into the power for the head unit. It made a...
  3. Replies
    43
    Views
    2,324

    Your right about that being for 4 speakers on one...

    Your right about that being for 4 speakers on one channel, didn't notice that at first I guess. Work can be distracting sometimes!! These Polks sound good for the money but they are kind of a pain.
  4. Replies
    43
    Views
    2,324

    According to the sight if you do the series...

    According to the sight if you do the series parallel combo the amp will still see the 3ohm load which will allow the amp to push the same power its pushing now. It looks a little complicated but...
  5. Replies
    43
    Views
    2,324

    Hey bzubke1 check out this sight on different...

    Hey bzubke1 check out this sight on different wireing options. The third example combines series and parallel to keep lowering the 3ohm load. This might let you hook up that other pair of cabin...
  6. Replies
    43
    Views
    2,324

    Pre Amp signal. Stupid auto correct text.

    Pre Amp signal. Stupid auto correct text.
  7. Replies
    43
    Views
    2,324

    Ok, just for conversation. I bought this amp...

    Ok, just for conversation. I bought this amp because my buddy's new (2010) enzo runs 3 of these amps and they scream. This is the factory system, all skylon speakers. 6 in boat coax 6.5's on one...
  8. Replies
    43
    Views
    2,324

    Thanks for the input Brian. You confirmed my...

    Thanks for the input Brian. You confirmed my decision to just run on 2 of the 4 channels. Like I said before, I usually over analyze things ahead of time so I don't have these problems. This time I...
  9. Replies
    43
    Views
    2,324

    That makes sense. Thanks man. I may have another...

    That makes sense. Thanks man. I may have another use for this amp, but I'll have to run it for now. Definitely don't think I'm gonna bridge it.
  10. Replies
    43
    Views
    2,324

    That's what I always though too, bridged equals...

    That's what I always though too, bridged equals 2ohms, but that is based on using 4ohm speakers right? The manual states bridged power is 175 watts at 4ohms not 2ohms, that confused me. I think they...
  11. Replies
    43
    Views
    2,324

    So the Kicker 350.4 was waiting at my door when I...

    So the Kicker 350.4 was waiting at my door when I got home from work. The certificate said 425 watts total. I hooked it up straight not bridged and measured the ohms at the amp while running, it...
  12. Replies
    43
    Views
    2,324

    That's one thing I was worried about. My buddies...

    That's one thing I was worried about. My buddies new (2010) Centurion Enzo is running three of these amps and I was impressed with them, so I ordered one to run my new tower speakers. Mabey I...
  13. Replies
    43
    Views
    2,324

    Thanks for the multi meter suggestion, guess I...

    Thanks for the multi meter suggestion, guess I should have thought of that. The Polks measure 3.3ohms and an old speaker I had just laying around measured 3.8. I guess they are a lower ohm speaker....
  14. Replies
    43
    Views
    2,324

    To bridge or not to bridge

    I just installed a pair of Polk MM651UM speakers in my tower cans, and will be running them with a kicker 350.4. Should I just run them off 2 of the channels and save the other channels, or should...
  15. Pulled the factory thru-hull today. I used a...

    Pulled the factory thru-hull today. I used a heat gun to warm the sealant and a long 1/2" extention to wiggle it loose from the top. I'm ordering a 1" from wakemakers, the hole in the hull is about...
  16. Sorry. Guess that was kinda vague. I'm using both...

    Sorry. Guess that was kinda vague. I'm using both to fill through sprinkled valves. Looks like they only draw half the amps of the rule, so guess I could just connect into factory wiring. Am I...
  17. Any suggestions on the best way to wire in the...

    Any suggestions on the best way to wire in the dual 1200's?
  18. Awesome. Sounds like the 1" 1200' s will work...

    Awesome. Sounds like the 1" 1200' s will work great as drain pumps.
    On another note. I pulled the floor panels up and noticed the lines for the front ballast bag were crushes at the front of the...
  19. Anybody ever run the 1200's for empty pumps?

    Anybody ever run the 1200's for empty pumps?
  20. Replacing 700gph Rule with Tsunami 800. Is it worth it?

    So I'm upgrading my ballast intake to dual Tsunami 1200's with a larger manifold for the three sprinkler valves. I know this isn't the best way but it fits my budget. So my plan also included...
  21. Replies
    5
    Views
    753

    Sorry should have said tower speakers. Here is a...

    Sorry should have said tower speakers. Here is a link to the Bazooka sight check them out.
    ...
  22. Replies
    5
    Views
    753

    Bazooka Tubbies

    Does anyone know anything about these? I have used several Bazooka subs, which are great, wondering if these work as well. I just can't afford wetsounds or the like. I'm looking for something more...
  23. Replies
    10
    Views
    2,042

    I had a similar problem this year on my 05 Supra....

    I had a similar problem this year on my 05 Supra. If your paddle wheel unit is like mine there is a bundle of wires coming out of it. About 6 inches from the unit is a big plug. Unplug it and make...
  24. Add me to the list too. 2005 Supra 21V. I found...

    Add me to the list too. 2005 Supra 21V. I found the water about 2 years ago, and after having the dealership get it out and then repairing their hole it filled up again. I put in a 6" access...
Results 1 to 24 of 24