After laying out my custom design I anxiously waited for about a month to have it made, and when it showed up I couldn't wait to get the thing installed! I went out last night and got the job done, and I have the blisters to prove it!
Removing the old pad was easier than I thought, but getting all the leftover adhesive was a bit of a pain. I used mineral spirits and elbow grease, took about 45 minutes.
I did all this with the boat in the water, which was a little tricky, but not too bad.
On with the pics!
Checking them out!
Old pad removed, you can see the adhesive that I had to remove before installing the new pad:
Cleaned up and ready to rock!
Test fitting the new pad. I layed it out and held in place with blue tape, then peeled one corner of the backing off, layed it down and then removed the rest of the backing. This made the installation a snap, and ensured my lines were straight and spacing was correct:
Results 1 to 10 of 12
06-04-2010, 11:33 AM #1
The installation of my SeaDek Swim Platform Pad...
06-04-2010, 11:34 AM #2
and the finished product!
06-04-2010, 11:49 AM #3
turned out really cool ian. Now go use it right?2007 Moomba Outback - waiting for summer!
Why Not? Play Hard! Get wet
06-04-2010, 12:24 PM #4
I can't wait! Unfortunately my ski partner (aka my dad) is going on the Hot Rod Power Tour and won't be home for like a week, so I'll have to con my girlfriend into driving or something!
06-04-2010, 12:57 PM #5
Looks great, Ian. Enjoy!My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)
06-04-2010, 01:05 PM #6
nice job. looks good.'06 Supra Launch 20SSV-gone but never forgotten
06-04-2010, 02:30 PM #7Senior Member
- Join Date
- Feb 2009
- Seattle, WA
looks sweet ! nice work ...----
06-05-2010, 11:32 AM #8
Ian, thats looks great, way impressed that you also did it on the waterHey, Its Moomba time
13 Mobius LSV
08 Mobius LSV-sold
03 Mobius LSV-sold
06-05-2010, 12:12 PM #9
06-05-2010, 12:50 PM #10
Very coolio... What are the specific colors that you used?2007 Mobius LSV