Results 1 to 4 of 4

Hybrid View

  1. #1
    Join Date
    Jun 2002
    Location
    La Grange Park, IL
    Posts
    42

    Default Rewiring power for stereo

    Have a bad connection for the stereo power. In and out constantly. How/where can I wire the power wire on the board. Would like to go the ACC if possible (currently not used)
    Fins to the left.

    2002 Outback LS

  2. #2
    Join Date
    Jun 2002
    Location
    La Grange Park, IL
    Posts
    42

    Default

    Back to top....hoping to get suggestions
    Fins to the left.

    2002 Outback LS

  3. #3
    Join Date
    Oct 2010
    Location
    Lake Wylie NC Area
    Posts
    721

    Default

    Are you looking to relocate the head-unit's yellow B+/MEM or the small red switched turn-on?

    The yellow B+ needs to be on a content 12V+. If you have amps, it needs to share the same battery source as the amps do.

    The red turn-on can either b e switched but the key cylinder or a rocker switch. It draws very little current, so dont worry about a heavy load. If going to the key switch, there should be a terminal labeled ACC. If going to a toggle switch, then fallow the wiring diagram for the switch. You will need B+ coming in and then connect the wire to the head-units turn-on wire to the other terminal on the switch. If the switch has a light, there will be a 3rd terminal that will be the ground side of the light.

  4. #4
    Join Date
    Oct 2010
    Location
    Winnipeg, Manitoba
    Posts
    362

    Default

    I had the same problem with my sub amp. If you have an inline fuse, check that. The connection to that was corroded.
    past---------------2003 Outback SOLD
    present------------2006 Supra Launch 21V
    possible future-----2013 Mojo

    Ron

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •