Installed the radio tonight. Both driver and transom remotes work. I was not able to test if it will change tracks on the i-pod but I will check that this weekend.
Results 21 to 24 of 24
04-19-2011, 10:53 PM #21SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
04-19-2011, 11:04 PM #22
Make sure the play mode on the 440u is in hands off mode and u can skip tracks with the remote . If the ipod is hooked up to the usb
04-20-2011, 11:26 AM #23
E4 yes tape the area up with a couple layers of tape, this helps stop chipping and the bit wont walk as easy. Always start in reverse when drilling and use a sharp bit. You can switch to forward once your threw the gell coat but most of the time i just drill it in reverse.Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
6 SX65M Cabins
6 XM9 Towers
1 XI Big 15 Woofer in a custom Fiberglass box
1 XI 1K Harpoon
2 XI 800.4
1 XI 2500.1
2 Interstate 2400U 6V Golf Cart Batterties
Custom 1 Off Evolution Cover
10-27-2012, 09:49 PM #24
Sorry to resurrect an old thread, but I figured that this was the best place for this info..
The Kenwood KDC-352U works just fine with the Aeware remote. I would be willing to bet that the following work too, which share an instruction manual w/ the 352U:
2005 Moomba Mobius LSV