Has anyone ran heater vents to the passenger side?

[ian ashton]

I'm thinking about T-ing off one of my vent tubes and running it to the passenger side, so there is a pull-out tube under the passenger seat. Just curious if anyone has done this before, and if running a length that long will need an additional fan or anything - or if it will even work at that length.

My thought is that I'd have to run it up through the bow and back down.

[mmandley]

There was talk of this but in the end if you just run them down the drivers side and exit at the floor, the tubs will extend to the passenger side and then no need to run them all the way around. Also with the these tubes unless you changed them to a hard tube anything that presses on them would flatten them cutting off air flow.

[ian ashton]

I was thinking something like PVC for the long runs, tucked up in the space between the outer hull and the top cap, so its out of the way. Its a pipe dream at the moment (pun intended!)

[cab13367]

I was thinking something like PVC for the long runs, tucked up in the space between the outer hull and the top cap, so its out of the way. Its a pipe dream at the moment (pun intended!)

Ian,

I think you'd almost need to run PVC because with the flex hose, I think that you would not have much air flow left but the time it went around the bow.

Al

[jmvotto]

why the need with the pull out tubes...?

[jamie_abb]

why the need with the pull out tubes...?

Totally agree

[ian ashton]

why the need with the pull out tubes...?

Why not? Mostly because they don't reach to the back seat. I don't know, just thinking of another project. I'm also working on adding a pump to drain my cooler; why? 'cause.