Ran into an unusual problem yesterday. The Nav and aft light are on the same switch. Usually you can turn on the nav (bow) and panel alone, or select the switch to use nav and stern light. Yesterday it was nav and panel or just stern light. Both went on, just not at teh same time. Any suggestions?
Results 1 to 4 of 4
Thread: Navagation and aft light issue
06-27-2011, 03:07 PM #1Member
- Join Date
- Jun 2002
- La Grange Park, IL
Navagation and aft light issueFins to the left.
2002 Outback LS
06-27-2011, 03:10 PM #2
Sounds like a three position switch where one or more of the positions has corrosion or a drop of moisture in there. I'd try removing it and cleaning the contacts before anything else.My Mom said I'm not allowed to get wet!
06-27-2011, 03:25 PM #3
Removing that switch is a HUGE PITA in my opinion...I broke mine trying to get it out when I was installing my LEDs.2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
06-27-2011, 04:22 PM #4
Well, you could try blowing some air into it and turning it off an on 50 times to see if it cleans up.My Mom said I'm not allowed to get wet!