Results 21 to 26 of 26
Thread: DIY: Tower Pad Swap Out
06-11-2013, 03:14 PM #21Member
- Join Date
- Jun 2005
- Michigan City, IN
UPDATE: Ok so, i had to re-do my port side yesterday! the pads are working great, the starboard side is still looking like it did the day i put it it, but the reason for the port slipping out, was i cut the pad too small, the outside screw/bolt cut its way out of the pad because there was not enough space from the hole for the screw to the edge of the pad, it cut out, hence pad started to eventually slip out.
so i made the pad cut a little bigger, showing about 1/2 inch of pad on each end of tower, i also tossed the wrench and got my socket set out, 7/16 w/ extension bar and a swivel socket, was able to tighten down MUCH better, i even re-tightened the startboard side just for good measure and was amazed on how loose i actually had the screw/bolts.
So my advice is make the new pad cut alittle bigger than your original pads and have them stick out a bit more so the screw holes cant slip and get "cut out" as easy and also get a swivel socket to tighten down a little better where it pushes/squeezes down the pad a little that should help w/ movement and slipping.
Last edited by mmobius2001; 06-11-2013 at 03:16 PM.2006 Mobius LSV
06-11-2013, 04:39 PM #22
Yeah, I just had the dealer do this for me...so much easier.SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
06-11-2013, 07:54 PM #23Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
06-12-2013, 07:35 PM #24
Its nice to have someone will small hands too. It was hard to get the screws back on underneath.2010 Moomba LSV
06-13-2013, 08:23 AM #25
06-13-2013, 11:03 AM #26Senior Member
2005 Mobius LSV
- Join Date
- Apr 2010
- saskatchewan, canada
Gravity IV (750s rear, 400 mid and 650 bow)
wakeplate, perfect pass,
Not sure what stereo I have, but I have 3 amps 2 subs 6 x 6.5 mids and tweets and 4 tower speakers ( 2 x 8 inch and 2 x 6.5 and tweets)
1433 acme prop