Hey guys. This is only my second post, but I spend a lot of time on the forum learning from you guys so thanks in advance. I am hoping to replace my tower speakers, but still use the stock Roswell cans that the Kicker factory speakers are in. I want to get something decent up there, but can't go too crazy yet as I want to keep my current amps. Long way of saying I am not ready for the EXILE path, just had a baby. Today I have a ZX 700.5 powering my cabin speakers(6) and a 12" Kicker sub. The two tower speakers are the stock kicker components in the roswell cans. They are powered by a kicker ZX 250.2. I was thinking i could replace the speakers with the Polk DB 651 or DB 6501. If i used the coax's instead of the components I would just leave the kicker tweeter grill on the cans and cut off the wire. Any thoughts on if there would be any issues with this change out? In particular I am concerned about size and power concerns. Also, I have been toying with the idea of adding set of polk DB 691's as a supplement to the two already there. With all polk DB on the tower would my amp be strong enough to power all 4 speakers very well? How would I need to change the amp set up to get the most power out of my tower? Thanks for any help you can provide. Also open to suggestions on other replacement speakers to consider that would fit the existing cans, either coax or component. The picture is not of my actual speakers but they look identical to these ones.
Screen shot 2012-02-09 at 9.41.05 PM.jpg
Results 1 to 10 of 18
02-10-2012, 12:45 AM #1Junior Member
- Join Date
- Aug 2009
- Maple Valley, WA
Tower Speakers - Need help replacing