Page 1 of 5 123 ... LastLast
Results 1 to 10 of 42
  1. #1
    Join Date
    Jun 2009
    Location
    Victoria BC Canada
    Posts
    663

    Default EQ Install Advice

    Anyone have some pictures of how they installed their EQ or ZLD under their dash? I've been searching the forums and found one post but the link it refers to has been removed.

    Thanks in advance!

    Wade
    2011 President's Trophy - Check
    2011 Western Confernece Champs - Check
    2011 Stanley Cup Champs - Not so Much....

    2007 Outback V

  2. #2
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    5,744

    Default

    Wade, on the obv I put two l brackets on the steering column bolts then added some lock washers an nutsthen screwed some plastics board a tad bigger than the eq to the brackets. Then just mounted the eq to the board flush to the board. Its only place I could find to mount on the obv, not enough dash board anywhere else.

    Check out my profile pics.

    Joe
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

  3. #3
    Join Date
    Apr 2011
    Location
    NY
    Posts
    203

    Default

    Wade - I ran into a similar problem this spring. I followed JM's instructions as indicated above. Worked great. All you need is a couple L brackets from Lowes, nuts, washers, and a "board" cut so size. I thought I would have some starboard left over from my amp rack but unf. I didn't. I went to Target and picked up one of these and cut to size: http://www.target.com/p/superboard-p...4x17/-/A-85899
    IMG00005-20120506-2017.jpg
    '06 Outback - Gone but not forgotten
    '13 Mojo

  4. #4
    Join Date
    Jun 2008
    Posts
    110

    Default

    I mounted mine below the throttle by the gravity III switches. With a trim piece from a stereo place, it looks pretty clean and its at your finger tips for volume control.
    Jason

    2008 Outback V with closed cooling
    Gravity III upgraded to 750's in the rear
    Wetsounds Pro 80s with JL amps for boat and tower
    RF Punch Sub with JL amp

  5. #5
    Join Date
    May 2010
    Location
    Muskoka, Ontario
    Posts
    386

    Default

    I just ended up doing my krypt eq this past weekend.

    Did what was suggested above. Cut a piece of 1/2 inch plywood just slightly wider than eq, bolted it below the oem switch panel on right side with 2 L brackets, mounted eq to board and also attached a piece of wire to the board near the rear to stop any movement up and down on big waves etc, it's solid.

  6. #6
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    5,744

    Default

    here is the pic
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

  7. #7
    Join Date
    Jul 2008
    Location
    Des Moines, IA
    Posts
    2,574

  8. #8
    Join Date
    May 2009
    Location
    Carlton Oregon
    Posts
    5,989

    Default

    Quote Originally Posted by brain_rinse View Post
    Tried to PM you, says your full mang =(
    Malo <--- Means--Evil or Mean One. This explains a lot.
    2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
    Exile ZLD
    6 SX65M Cabins
    6 XM9 Towers
    1 XI Big 15 Woofer in a custom Fiberglass box
    1 XI 1K Harpoon
    2 XI 800.4
    1 XI 2500.1
    2 Interstate 2400U 6V Golf Cart Batterties
    Custom 1 Off Evolution Cover

  9. #9
    Join Date
    May 2010
    Location
    Muskoka, Ontario
    Posts
    386

    Default

    that looks good! on our 2010 i dont think i have the room under the switches to do that though

  10. #10
    Join Date
    May 2009
    Location
    Carlton Oregon
    Posts
    5,989

    Default

    Quote Originally Posted by loudsubz View Post
    that looks good! on our 2010 i dont think i have the room under the switches to do that though
    You have to buy a blank and move the switches up. i have a blank i was trying to contact Brain for any tips before i break out the dremmel. I will take some pics and do a write up if i can get this done LOL.
    Malo <--- Means--Evil or Mean One. This explains a lot.
    2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
    Exile ZLD
    6 SX65M Cabins
    6 XM9 Towers
    1 XI Big 15 Woofer in a custom Fiberglass box
    1 XI 1K Harpoon
    2 XI 800.4
    1 XI 2500.1
    2 Interstate 2400U 6V Golf Cart Batterties
    Custom 1 Off Evolution Cover

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •