Exiled...

[ian ashton]

All the holes are cut and the wires run, we just had to trim the vinyl out to mount the speaker in the factory location.

[jmvotto]

All the holes are cut and the wires run, we just had to trim the vinyl out to mount the speaker in the factory location.

glad your doing in on someone elses boat, vinyl cuts would not be in my mod list .

[EarmarkMarine]

Vinyl cuts are no big deal....BUT, you must correctly terminate the vinyl (beyond the four speaker screws) so that it has no ability to stretch. Otherwise you may have issues later.

David
Earmark Marine

[bergermaister]

glad your doing in on someone elses boat, vinyl cuts would not be in my mod list .

Helped a buddy do this to his little Blue Water runabout during an install last year. I was cringing when we cut the first hole through the vinyl for the 6.5" near one of the rear seats but it really wasn't that bad at all surprisingly. Was still glad it was HIS boat though for those first few seconds!

[ian ashton]

Bow speakers installed;




Xi800.4 on top, Harpoon on bottom;


The start of distribution blocks;

[E4NASH]

How long are those screws that you used to mount the amp board and the distros?


Sent from my iPhone using Tapatalk

[ian ashton]

3/8" or 1/2" I don't recall. The are they are screwed into is super thick.

[C.Hern5972]

very nice... Cant wait to get my exile installed

[Brianinpdx]

I gotta say, that green vinyl is a super cool color. Install is looking good Ian. Will be fun to see that boat on the water rocking loud. That's Chase's boat right?

@Chris; You working with Travis right? If so, that guy cracks me up. He's nuts!~ But does know what he's doing. I never did hear what the final configuration was.

[bzubke1]

Do you happen to know the model number on those distribution blocks? I've been looking for a single input to a 4 output.